Just found out today the normal gate we have used in the past to enter the campground is closed. They asked us to use their new gate (Gate #2) which is just past the old one, I assume on the same access road.
We will be arriving on Tuesday (10/1), using our P/A for the two days before the rally...
Thanks Bill... yes, I did look at the fuse end....5 Amp 125 volt, but it didn't specify GMA or GDC. I have a GMA in there now.....so far so good. Must have just been an anomaly or something. Sad that Dometic couldn't tell me anything.........
Does anyone know which type of glass fuse (5A 125V) is used in this unit?? Not sure if it's supposed to have a GMA 5A 5mmX20mm fast blow, or a GDC 5A slow blow?
After resetting the GFI from an apparent overload, I noticed the unit would only run on LP, not A/C. Further troubleshooting revealed...
Dave, booked today for arrival 10/2, leaving 10/6 for Fisherman's corner COE overnight on the way back.
Awaiting curbside booking confirmation sometime in August.
Please add us to the list. thanks
Jim & Claudia
Holland Michigan
- - - Updated - - -
Hey Bill.....you don't drink beer, do...
Does anyone know how to adjust the flapper on the bottom of the left lower door so that it glides into the guide plate without having to slightly lift the door so that the flapper pin falls into the guide plate?
Searching the forum, there was a post by Dan in 2012 about a new guide plate, but...
Just stopped by the campground today after visiting my brother who lives in Jennison.
There were a good number of campers there and also a good amount water in the river.
The river was very high and the owners put an extra ramp just to get to the office. Very nice folks. We did not see any...
We have a complete set (front and rear) of Lippert JT Strong arm stabilizers. We have a new camper that has hydraulic stabilizers, and can't use these any longer.
$100.00
Jim
616-566-4164
Thanks Marc.....I will call the selling dealer now that I know what it looks like.....or I might get one at my local big box store and be done with it.
Thanks.....the two valves on the top of the manifold are for the leveling jacks. The valve on the bottom is for the slides. The master landing jack contains it's own valve which is between the walls and on the blind side of the rv way up at an arm's length. Not an easy maneuver to get the 5/32"...
Just wondering for anyone else that has the Lippert 6 point leveling system, how many manifolds (trombetta) do you have? My 2019, 31RLK Elkridge has only one manifold. A conversation with Lippert claims that there should be two manifolds.....one for extend, and one for retract. If you look at...
Is Heartland or the dealership responsible to provide the drill adapter? I did not get one in my blue bag.
Can someone post a picture of it so that I can get one?? Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.