I’ve got a 2024 Torque T295 with the generator prep package. I’m weighing my options as far as installing one or just using a generator I’ve got. It appears that all the controls and fuel lines are there but there’s no 120V there to hook to the generator. Do I just have to run the regular shore power cord to the generator? Is the fuel pump already installed or would I need to purchase the Onan fuel pump kit? Has anyone added the separate fuel tank for the generator? Thanks for any help you can offer.
Generator Prep Install Questions
- Thread starter RiverManJ
- Start date
Dahillbilly
Well-known member
look for a 4" square electrical box w/ cover near the generator compartment. should have the wires going out to the transfer switch.
Torque Man
Member
Mine is under the bed. Remove plywood under mattress on top of bed platform, (over top of generator compartment). 4" electrical box screwed to floor on right side of bed.
Torque Man
Member
If the wire & box is under the bed, then the transfer switch is installed. The TS is mounted to the back of your circuit breaker panel.
The 4 x 4 box in my unit is installed on the opposite wall for the generator box inside the storage unit on the opposite side of the trailer.
Torque Man
Member
If you have the fuel station and you can see the fuel tank hanging down in front of the spare tire, you are good to go. The gen. gets its fuel from the same tank. You should also see two rubber fuel lines running from the gen compartment, running along the main frame I-beam to the rear fuel tank.
The fuel pump is on the generator in my unit. There are two lines a suction and return line.
Similar threads
