2010 Cyclone 3010 weight

Since this is a new model, and for 2010 they apparently don't give an "exit the plant" weight spec.

Our trailer is at MorRyde for upgrades.

These weights are with full water (should be 100 gallons) and some water in the holding tanks.
Full propane tanks
About 1/2 fuel

Generator
Washer Dryer in the bedroom closet

Whatever I could bring with me from New Jersey for the pickup of the trailer. I would guess I added less the 100 pounds

Pin weight 2500
L/F 2850 R/F 2865
L/R 2375 R/R 2380

Left side 5225 Right side 5245

Front axle 5715
Rear axle 4755
Total axles 10470

pin 2500
Total 12970
GVW 14000
Cargo 1030

Motorcycle weighs about 800, add another 100#'s of bike stuff.

Leaves only 100 pounds for Deb!

Good things the axles are rated at 7K I think we may be over on occasion

porthole said:

Check for a sticker on the entrance door jamb and another sticker outside on the off-door-side, sidewall under the bedroom slide up near the goose neck area.

Subtract the CCC from the GVWR to derive the actual weight of the unit as it left the plant.

About model years ago, RVIA rules changed on type and placement of these stickers. So they're no longer put in the cabinets.

Click to expand...

I found the sticker on the door jamb, but it does not list the "out the door" weight.
All it has is my VIN and a cargo capacity of 1630 pounds.

I am going to guess that the advertised dry weight is with minimal options.

Rough math tells me then that the Washer Dryer combo, generator and dual pane windows = 845 pounds
(14,000-11,525=2,475-1630=845 pounds for options over base)