wiring 110 volt

installed an approved electric fireplace in my 2008 Sundance 3300SK but factory installed outlet did not have wiring going back to the electric panel. it was wired back to junction box in slide out and to a cable that disappeared into under carriage. anyone no where circuit ends???

Thanks,
CP
 

Ray LeTourneau

Senior Member - Past Moderator
My initial guess is that it ends behind the electric breaker box with the ends taped up and ready to be connected to a breaker. You would have to pull the outer cover and expose the screws to remove the box itself and look behind it for an extra set of AC wires and use a meter to see if they go to the outlet you need. But that's just a guess.:confused: You might also need to purchase a breaker.
 

ludwigdavid

David & Diana
Check the switch for the ac and fireplace, be sure it is in the fireplace position. its on the wall of the hall going into the bedroom
 
Last edited:
Top