Rear Stabilizing Jacks

My jacks were on 4 inch box tubing. I removed the box tubing to allow the jacks to be completely recessed. I discovered this after nearly getting stuck because the jacks sat way too low. Naturally this means the jacks could have been ripped out as well. They were originally welded in, but i bolted mine back in with four 3/8" bolts on each side.

I will be doing the same the next time i bend one of those jacks again as they hang a way to low for certain road conditions.
No problem changing that over?

it was easy. a bit time consuming because they were all welded in. i used pneumatic cut off tools and electric grinders to get it done. you will also need a big hammer, a ball peen hammer, and a big chisel. it took way longer to remove, then to install.