SilverRhino
Well-known member
I finally got around to mounting the level on the pin box. While trailer was in storage...tooke all the measurements and then fabricated bracket at home. When I brought the trailer home this week, boy was I happy....it Fit!
I used a strip of 1/8" X 1" aluminum flat stock. To bend the angles....placed two small pieces of 1/2" dowel in vise jaws with the bar.....this gave me the radius that I wanted. Riveted the cross pieces on with stainless steel rivets and mounted level to bracket with stainless steel machine screws and nuts.
Mounted whole unit to pin box using original screws....placed nylon washers under the bracket.
Travel Safe!
I used a strip of 1/8" X 1" aluminum flat stock. To bend the angles....placed two small pieces of 1/2" dowel in vise jaws with the bar.....this gave me the radius that I wanted. Riveted the cross pieces on with stainless steel rivets and mounted level to bracket with stainless steel machine screws and nuts.
Mounted whole unit to pin box using original screws....placed nylon washers under the bracket.
Travel Safe!