Loose dining table

piach

Member
We have an 09 Big Country that has the dinette booth. The table is supported by two poles. When in place, the table rocks back and forth eaisly with very little pressure. I understand some movement is expected but this is pretty extreme. Pressing with one finger lightly can "rock" the table a good 6 inches. Just looking for any way to "tighten" the table up so when we eat we are not spilling everying from one side to the other each time elbows (sorry our kids are 4 and 6) rest on the table.
 

Ray LeTourneau

Senior Member - Past Moderator
For starters. Make sure the Mounts on the floor and under the table are secure (screwed down tight). The next thing to check is the alignment of those mounts. Measure the distance between the ones on the floor and compare that to the ones under the table. Any variation will cause the table posts to not seat properly. If they are lined up right, put a good amount of pressure directly over the center of the table to seat them good. That's the best I can tell you. Good Luck.
 
Top