PDA

View Full Version : Hydraulic Issue - Slides go out at odd times



Chainsaw
09-07-2010, 07:51 AM
When I put out one slide another will go at the same time. Yesterday when I was rasing the legs the bedroom slide came out, I didn't realize this until I went to pull away ansaw it half out. I went and put the slide in. when I got to our storage place I put the legs down (which took a long time) When I went to pull away from the trialer the bed slide was half out again. I then started checking. Flued was where it was marked on the container, all slides worked. Any ideas?

fljlcw
09-07-2010, 08:24 AM
sounds like the valve body has trash or A bad O-ring

Chainsaw
09-07-2010, 03:55 PM
Thanks will check it out

Willym
09-07-2010, 07:53 PM
On our first outing the bedroom slide would move when other slides were operated. I suspect the the solenoid operated hydraulic valve that directs oil to the bedroom slide ram was passing a bit. After a while it stopped and has been fine since. There could be some debris in the valve causing it to pass. You could exercise the bedroom slide a number of times and this may flush out out the valve and remedy your situation.

Let us know how this turns out.