slide adjustment?

the bottom of my slide is out about an inch just touching the seal the top is tight compressing the seal.is there an adjustment to suck in the bottom?
 

Bob&Patty

Founders of SoCal Chapter
Yes there is. Look under the slide. You will see square vertical "feet" with nuts and bolts. They are attached to the square tubing that holds the slide. They are bolted to the outside wall of the slide at the bottom. Then look for the 2 vertical "thru" bolts. You will see that they are treaded in such away to move the slide up or down If you loosen those bolts and lock nuts....the whole slide will drop drop by turning the bolts "down". That will bring the bottom of the slide in. It wont take very much. Do it a little at a time. When I did mine... I had to run the slide in and out each time I made an adjustment. Its not hard to do just takes a little time.
 
Top