Trail Air pin box

bdb2047

Well-known member
Has anyone tried to move pin box up in Landmark?I would like to raise box 1 hole to get clearence for tri-glide jaw.Although there is 1 set of holes cannot raise due clearnce problem.I can get 1 bolt in each side of front row but cannot get back holes to line up.Box hits at top corner when I try raise rear of box to line up holes.I could lower hitch in truck,just not sure if that would create a problem w/bed clearence and lower jaw.
 

cookie

Administrator
Staff member
Re: Trai Air pin box

At the rally in Nashville, we installed a Tri-Glide on a Bighorn and were able to get it in the top holes. It went in with some resistance. I recall someone recently said something about a little bit of the frame is in the way to get the pinbox higher. I guess we were lucky.
When I had the Tri-Glide installed I took the easy route and lowered the hitch. Worked fine.
Let us know what the final outcome is.

Peace
Dave
 
Top