Landing gear collapses slowly

gbwizard

Member
I have a 2005 Landmark and recently took it out of storage to use for the winter, we're snowbirds. I parked and raised the front to a desired level. I noticed approximately 10 minutes later the unit had slowly dropped down to it's lowest level. I raised the unit again, and again it dropped down slowly. The hydraulic fluid level in the reservoir is at the correct level and did not change. Couldn't find any leaks also.
 

cookie

Administrator
Staff member
Hello Gbwizard and welcome to the forum.
I has a similar problem with a hydraulic slide. Would not hold the pressure. The problem was a bad hydraulic cylinder. It was bypassing the seals internally and loosing pressure from one side to the other. There was no fluid leak. The fix was a new cylinder.
This sounds like what might be happening to your landing gear.
When I find some hydraulic trouble shooting information I will post it to this thread.

Peace
Dave
 

jmgratz

Original Owners Club Member
I would call Lippert (phone number is on the side of the page) and they can help u troubleshoot and supply any needed parts.
 

cookie

Administrator
Staff member
I found a little information RIGHT HERE. Look around and see what applies to your situation.
Hope this helps you out,

Peace
Dave
 
Top