mrcomer
Past Ohio Chapter Leaders (Founding)
I finally finished winterizing my rig last night and thought I would just finish off the remaining antifreeze by pumping it all into the rig and not having any leftover. Went to turn on the kitchen faucet and there was no pressure. Not sure what is going on here because I had already completely winterized the system using the pump just 5 minutes earlier. All I was trying to do is finish off the leftover antifreeze. I looked at my control panel to see if I had maybe turned it off and forgotten just that quick. I looked and the light was off. I turned the switch and no light in either position. I looked at the fuse in the fuse panel and it is just fine. Pulled it out an looked at it---fine. So I checked the fuse at the pump. It to if fine. SOOOOO, what do you all think is the next step? I figure I might have to start by tracing the wires to see if there is a short somewhere, but if there is I am sure one of the fuses would have burnt. I also figure I might hav eto pull the panel and chack the connection to the switch. Any other thoughts.
Thanks in advance,
Mark
Thanks in advance,
Mark