Slides stop

We have had a problem where the slides on our 3055 stop moving as they are opening or closing. Releasing the button and waiting about a minute we can get them to open or close. (Thermo switch??) Also had the same problem with the left forward extension jack. The hydraulic fluid level in the reservoir is a little over half full. Should it be 3/4? Anyone having a problem like this or a solution, I would love to hear what the fix was.

Thank you,
Jim

It sounds like the breaker for your hydraulic pump is weak and needs replacement. The breaker is an auto reset type hence the wait and then you can go again.
Some people have replaced that breaker with an 80amp auto reset.
The fluid in the reservoir should be at about 1/2 inch from the top when everything is retracted.

Peace
Dave