ATF: Big Country - 2009 BC Front Landing Stabilizer Motor Loose

I noticed last weekend that my front stabilizer motor had came loose and was binding and making noise when either going up or down. I looked it over and I can't see anything broken? I ended up taking a C Clamp and making it tight again. Any ideas? Is there a place I could look at a picture of a parts break down to see what holds it tight? My model is a 2009 Big Country 5th Wheel 3285.
 

Ray LeTourneau

Senior Member - Past Moderator
66Vettster, the gearbox is a floating system on a cross shaft and will move a bit under normal situations. There are a few bolt/screws around the perimeter of the gearbox that may be loose. It's been a couple years and our rig isn't here so I can't tell how many but the box should be visible from the front storage compartment. Make sure those screw are pretty snug. I don't know of a torque value but just snug em up good.
 
Top