BIGRIGFORUS
Member
While setting up my satellite system, I found a cable fault in the livingroom tv area. The dealer suggested I beep out all cables for my connection to satellite. This was a quick and easy test to preform. Unfortunatly the failed cable could not easly be pulled through and replaced. After some investagation I found a clean path for a new installion of cable to connect in the bedroom area. Here is the coxial cable run, first rout through the access port in the storage bay, then upward along the frame (must remove overhead panel for this run) drill 1/2 inch hole through the floor to finish the cable run. (note, always double check before drilling any holes in the floor that the path is clear and the cable will break as close to the wall without creating any obstructions.) Used a wireless HDMI extender to complete the connections between all three TV's. Another learning experience with my Direct TV connections. PS- A quick short term solution for same day service, run a cable through the window, and tape the gap. Not pretty, but it works!
Last edited: