PDA

View Full Version : Access Panel for water pump in the basement area



MdMike
04-13-2013, 09:57 PM
I would like to see an access panel added to basement of the 5th wheel campers... My 2011 BHCK did not have one. You needed to remove the entire rear basement wall to access the water pump and valves for winterizing. I have since cut and modified my own panel, but I am sure a factory job would look a bit nicer plus, it is just common sense to have one for this reason.

jnbhobe
04-14-2013, 07:39 AM
I just mounted hinges on the 4 corners and use hitch pins instead of the hinge pins.

porthole
04-14-2013, 09:07 AM
I used a marine "pie plate" in the area of the winterizing valves.

2nd picture in this post
//heartlandowners.org/showthread.php/11365-And-so-it-begins?p=83083&viewfull=1#post83083

TravelTiger
04-14-2013, 09:25 AM
Our ElkRidge has a panel, about 18" square, to access the pump and winterizing valves. It was held on by screws, but we added velcro strips instead.


Sent from my iPhone using Tapatalk

Bob&Patty
04-14-2013, 10:19 AM
I installed a piano hinge and a barrel slide pin.