Jimnkarens
Active Member
Can anyone tell me what is included in the factory installed prep pakg for generators in the Bighorn? Is there an automatic transfer switch included?
I'm not sure where the start switch terminates, but I'm sure it doesn't go to the transfer switch. It should go directly to something on the generator. I think you'll find a junction box where the generator goes. The #6 wires from that junction box go to the input side of the transfer switch.If I understand, the transfer switch should already be wired into the electrical line from the start switch to the connector in the genset compartment.
Can anyone tell me what is included in the factory installed prep pakg for generators in the Bighorn? Is there an automatic transfer switch included?
Does the gen prep include the wires connected to the shore power and batteries from the transfer switch? And does it include the cables to connect the xfer switch to the genset?
Thx for all the advice.
Jim,
There should be a junction box in the genset compartment with #6 wiring going to the transfer switch. That's all that goes from genset to transfer switch.
A heavy 12V wire runs from the battery to the genset starter terminal. I don't know if that's part of the gen prep option. If you don't see an extra large diameter (probably RED) wire either in the genset area or at the battery, it may not be part of the option.