ILH
Well-known member
I've been pondering whether or not I can lower the top bunk to about a 40" height by drilling additional holes for the pins.
The reason I'm considering this is that I need a higher bed and change table for my son. The lower bunk, when resting on the floor, is too low and has the large gaps between the cushions. I think I would have to remove the stops (or alternatively just relocate them).
Does anybody see a reason why this wouldn't work?
The reason I'm considering this is that I need a higher bed and change table for my son. The lower bunk, when resting on the floor, is too low and has the large gaps between the cushions. I think I would have to remove the stops (or alternatively just relocate them).
Does anybody see a reason why this wouldn't work?
Last edited:
