Bed Shock repair

Freckles · May 23, 2008

Under bed shock supports that connect to osb came disconnect from bed platform shock dropped. Found that it was attached with shorter stapes then opposite side. Put back in place with 5 wood screws each side used a dremel to remove excess length on top side!! Good to go in about 20 Min !!

Ray LeTourneau · May 23, 2008

We had the same problem. I used 3, 1/4-20 countersunk machine screws and some wood glue to re-attach the smaller osb to the bed platform and put the nuts on the bottom of course. I then relocated the shock mount so it was closer to the edge of the platform frame. A little more than 20 minutes but same end result.

Bed Shock repair

Freckles

Founding New York Chapter Leader-Retired

Ray LeTourneau

Senior Member - Past Moderator

Similar threads