RW 355 Table too big for garage

pcm_15

Member
Picked up our new Road Warrior 355 last weekend. On our 2nd adventure this weekend. One thing that I have noticed and want to know if others have as well and what you have done if so. The table that fits in the 3 holes in the garage is pretty big. However, since the garage has a bathroom it is next to impossible to sit down on the bench on the side of the bathroom when the table is in place. Unless of course you can navigate through a 1/2" opening. Anyone else have the same issue?

Also, I found that the 2nd table which fits in the living room was not built properly. The two holes (no other name for them that I can think of) that are on the table portion are too wide apart to fit the corresponding holes in the floor. Assume I can fairly easily just unscrew and rescrew them into the right spots. Thanks for input.
 

Sarge

Well-known member
I needed to "adjust" the mounts on one of the inside tables also.

Apparently the factory specs call for randomly impact driving a few screws in at 300ftlbs...

Sarge
 
Top