Landmark - Pre wired camera

I have the observation camera in the rear and it does not have power. I checked the connection at the camera, no power there. Where can I look next?

Re: ATF: Landmark - Pre wired camera

If the camera is wired to the supplied wires, look around in the battery compartment for a fuse holder, usually a single inline one, with no fuse in it.

Re: ATF: Landmark - Pre wired camera

On our 2014 there is a switch in the generator compartment for the power.

I just spliced in a switch for my pre-wired camera on my 2016 Bighorn and I was surprised to find the power source to be connected into the inside fuse box. The power source was fuse #15 which also had the thermostat for the bedroom on the same fuse. Before I installed a switch the camera was on 24/7. I don't know where the LM power source but you might check for a blown fuse inside the unit.

Look for the fuse holder in the picture I posted, you will need to put a 10amp fuse in it to complete the circuit


Sent from my iPhone using Tapatalk