How do you read it. Left the dealer with full tank of water and arrived home to water leaking out. Checked the water level again still showed full. My water pump ran continuously, againt he sensor showed full water. I then added more water thinking the tank had somehow emptied. I ended up adding alot of water and found the tank had somehoe emptied in transit over 70 mile trip.
I see in other posts that the tank will empty because of the vents. However I am more concerned with the reason the panel is always showing full. I am probably not reading it correctly and the rig is parked slightly slanted toward the rear. Could it be that the sensors for the panel are located in the rear for the fresh water tank?.
I asked the dealer i purchased it from and they had no answer for me. The Cyclone i purchased was the first one they had seen, so this was new to them also.
I see in other posts that the tank will empty because of the vents. However I am more concerned with the reason the panel is always showing full. I am probably not reading it correctly and the rig is parked slightly slanted toward the rear. Could it be that the sensors for the panel are located in the rear for the fresh water tank?.
I asked the dealer i purchased it from and they had no answer for me. The Cyclone i purchased was the first one they had seen, so this was new to them also.