Welcome Back Light Feature

My welcome back feature has never worked. During my replacement of my inverter and working on another issue I pulled the EIB Control panel and found the delay relay that is connected to the entry lights. It has four wires with terminals that are not connected to anything. I could not see any other unplugged wires. See the attached pic, My door has a magnet. Where should I be looking for the switch and/or wires that I think connects to the relay?


Sent from my iPad using Tapatalk

Re: Welcome Back Light Feture

Gary,

I'm not sure if you've got the Welcome Back module (KIB) there. There are quite a few wires and the module I've seen has only 4.

Here's a photo of a typical module and wiring.


And this diagram shows how the wires would be connected.



And a closeup of the module.

Re: Welcome Back Light Feture

danemayer said:

Gary,

I'm not sure if you've got the Welcome Back module (KIB) there. There are quite a few wires and the module I've seen has only 4.

Here's a photo of a typical module and wiring.
View attachment 56079

And this diagram shows how the wires would be connected.

View attachment 56080

And a closeup of the module.

View attachment 56081

Click to expand...

That good be. I will pull it back out tomorrow and get better pics of it. It has three small green LED lights. When I turned the Entry lights off and on, the LED lights turned off/on so I though it might be the Module. It has no shrink wrap.


Sent from my iPad using Tapatalk