ryan09170
12-30-2020, 08:37 PM
Done a few things to our PI322 over the past couple years:
Updated to a full length queen bed - Unscrewed the bed platform and moved it by 6". Still leaves enough room for the bathroom door to fully swing.
Added 2nd AC unit in master bedroom with thermostat - RV is pre-wired including t-stat wires.
Updated headboard outlet to include USB power ports and added another outlet on the other side of the headboard w/ USB.
Outdoor kitchen - filled in countertop channel with silicon to prevent liquids from collecting.
Added a TV in the main cabin, on a removable mount...and also used the same mount outside above the speakers so we can move the TV in/out.
Added a bike rack on top of the pin box to carry 2 bikes. I used a geared 5th wheel hitch so there is no interference with the cab of my truck.
Added a rear bike rack to the bumper to carry the kids 3 bikes.
Added the standard Furrion backup camera - does not work too well, lots of dropped frames at speed.
Added Maxxair vent covers (x3).
Cleaned up the wiring behind the luggage compartment barrier - not a lot of pride in putting these things together, it was a mess!!
Its not on the camper, but I installed a 50A post, city water and a tap to the sewer on the back of my house...just in case I get kicked out :).
If anyone has any questions, feel free to contact me - I am more than willing to share pics (now that my warranty ran out).
I am thinking about running an antenna line from the camera to near the front of the camper so that the backup camera video is stable - looking for suggestions?
65012
Updated to a full length queen bed - Unscrewed the bed platform and moved it by 6". Still leaves enough room for the bathroom door to fully swing.
Added 2nd AC unit in master bedroom with thermostat - RV is pre-wired including t-stat wires.
Updated headboard outlet to include USB power ports and added another outlet on the other side of the headboard w/ USB.
Outdoor kitchen - filled in countertop channel with silicon to prevent liquids from collecting.
Added a TV in the main cabin, on a removable mount...and also used the same mount outside above the speakers so we can move the TV in/out.
Added a bike rack on top of the pin box to carry 2 bikes. I used a geared 5th wheel hitch so there is no interference with the cab of my truck.
Added a rear bike rack to the bumper to carry the kids 3 bikes.
Added the standard Furrion backup camera - does not work too well, lots of dropped frames at speed.
Added Maxxair vent covers (x3).
Cleaned up the wiring behind the luggage compartment barrier - not a lot of pride in putting these things together, it was a mess!!
Its not on the camper, but I installed a 50A post, city water and a tap to the sewer on the back of my house...just in case I get kicked out :).
If anyone has any questions, feel free to contact me - I am more than willing to share pics (now that my warranty ran out).
I am thinking about running an antenna line from the camera to near the front of the camper so that the backup camera video is stable - looking for suggestions?
65012