Recent content by crmfghtr

  1. crmfghtr

    Regret Purchase

    Thank you everyone. Can't say enough about the heartland family. I would love to take it to heartland, that way I know it will be fixed right. We contemplated taking it there but by the time we finish here in Utah, it will be too cold. So we are putting it in storage until November. We will...
  2. crmfghtr

    Regret Purchase

    In August we noticed the chloroplast sagging under the front and rear of our Landmark Concord. I crawled under neath and pushed on the center of the chloroplast and noticed it felt heavy. I then removed the bolts around the edge and about 10 to 15 gallons of gray water came roaring out. I...
  3. crmfghtr

    Extending Warranty Expiration

    In light of the current covid 19 situation throughout the USA I was wondering if Heartland will extend the expire dates of those owners who purchased new RV's right before the pandemic. Because of the travel restrictions and due to a number of dealers / service centers who are closed. Anyone...
  4. crmfghtr

    Sleep Number Mattress

    It is mandatory that you tilt it for travel. There are metal wire brackets at the foot of the bed that keep the mattress from sliding off the end when you push the button to raise or tilt the bed. The bed is motorized. We have been tilting it daily after we make the bed to give more floor space...
  5. crmfghtr

    Sleep Number Mattress

    Sounds like there is also some issues with the sleep number R5 mattress as well. They are pricey, $2400. Problem is the king mattress that comes with the Landmark is already developing sink holes on both sides. Was looking at the R5 mattress as an alternative, because of the adjustability. With...
  6. crmfghtr

    Sleep Number Mattress

    Hi All, Considering upgrading to a sleep number R5 mattress for our Landmark. Has anyone upgraded to one with the tilt bed in the Landmark? Curious if you have to deflate it to tilt the bed. Thanks,
  7. crmfghtr

    Pressure Relief Valve

    Update: The water pressure regulator was ok, I ended ou replacing the pressure relief valve. Flipping the relief valve only allowed it to open maybe 1/32 of an inch. So I think it was bad out of the gate because it had a rust stain on one side of the seat. Looked like it had been leaking for...
  8. crmfghtr

    Surface of my sofas starts to dissolve...

    If you can't find what you want or will fit, you can always have it reupholstered in the fabric of your choice.
  9. crmfghtr

    Pressure Relief Valve

    Thanks Dan, maybe my pressure regulator is defective. Let me try changing it and see if that is the culprit. I had 3 filters on the system due to rotten egg smell. I flushed the system this morning with bleach. I think there is alot of sulphur in the water where we are at. I have also been...
  10. crmfghtr

    Pressure Relief Valve

    Well I tried the paper towel and confirmed that the pressure relief valve is the cause of the leak. I also tried the steps outlined in the water heater.pdf. still has water in the pan every day. So, looks like it is doing it's job but why is the pressure or water temperature causing it to...
  11. crmfghtr

    Filtered Water

    Hello, Had to flush my fresh water system with bleach and I was wondering if the fresh water tank is filtered from the built in water filter before it goes into the fresh water tank. Does anyone know. Looked in the manual but I didn't see a reference to that. Thanks,
  12. crmfghtr

    Pressure Relief Valve

    Let me try those steps. I will let you know what the verdict is. Thanks for the advice.
  13. crmfghtr

    Pressure Relief Valve

    After almost 2 months in this new Landmark Concord, I have noticed water in the bottom of the water heater pan where the outside door is. The first time I thought I fixed the problem because the anode rod was leaking. I tighten the rod and it was still leaking. I opened the water heater guide...
  14. crmfghtr

    Converted bathroom door to pivot door.

    Great job. Looks like it came that way. We have the pivot door on the bathroom. Ours doesn't latch unless I put my foot under the door and lift it. How did you adjust the vertical height?
Top