Recent content by dieseldogsdad

I have a 2015 BH 3750FL and right under both rear slides in the corners the walls are delaminating. One side has actually started to crack the fiberglass. This seems to have progressively gotten worse over the past couple years. I have only ever crossed paths with one other owner of this model...

Just added Morryde stepabove steps to my Bighorn. Now my welcome back light doesn't work. I realize it works off of a magnet and you can see the magnet on the bottom of the door. I'm wondering is there a way to fix this to where it will work with these steps?

Today I looked for any loose wires or nuts and couldn't find any. I am still really not understanding how the slide (including the hydraulic ones), the landing gear (if operated from front button) and everything else works fine on 12v but not the LevelUp. When I unplug from shore power it reads...

I was having some issues after my last trip last summer. When I got home I went to set the RV up to clean it out and the LevelUp shut itself off. Front jacks worked off the front switch. Just got done driving for 2 hours so battery should have been charged. Slides would go in and out. Battery...

I always level with all the slides out. If you don't it may change slightly when you put them out.

Just an update on the Trailair. After four trips with it and putting about 5,000 miles on it I must say I love it. However if your air pressure is not correct you will not enjoy this hitch very much. Mine rides nicely right around 70 psi. My first trip was about 66 psi but I now have more junk...

Just tried to use both sofa beds this weekend and they do overlap. Wish I would have checked before the recall a few months ago, could have had it fixed while at the factory. Jbehrens, what did you do to correct it? Did you have to move both couches back all the way to the wall? How are the...

I think what MikeR is referring to is most 9 volt connectors look like this and the battery terminals would not plug into this connector backwards. Your CO detector must have some type of slip in blade setup.

The factory did mine and they relocated the valves back about 18" so it is possible.

Glad to hear that they expedited your repair work.

Missmurphee, did they give you an eta on your rv return?

I just installed it yesterday and drove it from my father in laws house to mine( only about 5 miles of back roads ). It seemed to pull really nice on that short trip. Hit some unavoidable potholes and the truck road rougher over them than the trailer. You can really see the trailer move but...

I got mine back last Sunday. I must say just looking at the trailer it looks good can't really tell that it didn't come this way. They seem to have fixed the fender alignment issue and they also relocated the tank valves further back. There are a couple things that bother me some though. 1- They...

Did you find the problem? I do not have any lights when I unplug shore power but my slides and hydraulic jacks work. I will have to look for this breaker.

Looks pretty slick. Do you have to have one of these for each camera or does it support multiple cameras?