Recent content by DragonRail

They hid all the wiring. they ran it in a channel in ceiling over the bathroom and down to the breaker box. They were not going to do that originally but once they got in there, they found the channel and off they went.. I have 3 CWs within 2 hours and i talked to all 3 and had them all 3 quote...

that is the perfect size but not sure how this one would work being that I need to bolt the face plate to it. the builtin models have the holes pre-drilled. this brings up another question, could I install an Over the Range until like the ons in the 5vers? not sure what i would bolt it to...

Our 2017 M325 has the 900W High Pointe microwave and we and to replace it with a Convection / Microwave. the cabinet opening dimensions are 20" wide x 13.5" tall x 15' deep. Is there a unit that will fit that space?

camping world in Raleigh did the work and did a good job. they even rewired the 2nd AC from add 30amp plug to the 2nd leg of the new box. not may picture to post as there is not much to see..

I need to replace the window in the kitchen are of my Mallard M325. any have a good place to get replacement windows. Will Heartland sell me one or is there a better place to look?

I know that this is an older thread, but we just had our 2017 M325 upgraded from 230 amp to 50 amp. Our Dealer did the work of replacing the main cable and control box as well as the 50 amp exterior plug. We had originally added a separate 30 amp plug for the second AC, but had it wired into the...

on all of our slides, when the slide are extended, these is a huge gap in the lower corners. what it he best way to seal these off? it not only lets in hot and cold but pest as well.. what can we do to fix this. the unit is only 3 months old.

nice. we are thinking about a 350 as well. looking forward the to the your first tow report..

turns out there was a crack in the filter housing. i replaced the filter housing and we are good to go.

the winterize valve is closed and the tank is full.. at first i though the water strainer/filter that is between the fresh water tank and the pump was pulling air but i removed it, cleaned the o-ring and put it back on and i still get a lot of air. i''ll check for cracks and maybe just buy a...

We tried using our fresh water tank on our Mallard 325 for the 1st time this weekend and pump pulls a lot of air. i mean to the point that the toilet will blast water out of the bowl. I checked all of the fittings on and around water pump but but did not find any loose fitting or leaks. when i...

same here..

the trailer has the Wide Track axles so i might be able to split them across 2 pads on the Cat Scale.. I don't have any good, full on side picture of the rig but i can tell you the the truck and trailer look level. you can only tell the from is higher by measuring the frame to ground height...

So we traded in our 25' Coleman for a new Mallard M325 and i am working to get the rig properly balanced. After several runs across the CAT scale and some tweaking on the Centerline TS hitch, i have the rig pulling great but i have a couple of issues that I'm looking for some help with. the...

We are loving the M325. we installed a second AC unit (gota get a black cover ), Slide toppers and battery cutoff switch. otherwise its pretty much stock... for now..