Recent content by Flooringit

Have these like brand new. Have the brackets to go into the elevator 400$ Located in north west Arkansas , Springdale area

Have a like new deck kit. Has the gate at the rear not the side. No steps. Has all the hardware 500$ in northwest Arkansas have the mounting brackets for cyclone and another can’t remember what they came off.

Mine is brass I tightened the fitting I haven’t see it leak again but I slept all night lol. I’ll be checking it next week

I came back today and water was dripping so I started looking as it was a pretty good drip. It was the hot water line on the back of the hot water heater. It must’ve been very slow and just kept going down the line. The lines for the slideout go out in that area. I have had a fan going for 3...

Water lines for the sink don’t even go into the floor. They are in the slide out. No clue where water would get in there

I will check this evening. It’s strange that it’s in that spot. Even if I drop coraplast there’s another black cloth holding in the insulation. What a pain. I move to this spot about a month ago. Was at last one a year and half never a issue. Maybe soemthong came loose when moving

Ok so I’m baffled here. I have a cyclone 2014 4000. And right in front of the couch I noticed a soft spot a week ago. I thought huh must’ve always been there , tonight I noticed it got bigger. So I took the cups out the hold the table, and the insulation is moist , stinks like mold. There is to...

I did the air flow mod, and right after that I started having issues. The air flow was great but the unit started freezing up. It freezes on the inside of the coil not the intake side with the sensor in it. I pulled off the cover after a night of ac running and the ice was a inch thick on the...

Well the chute is back togther. Wasn’t as bad as you’d think. I have it now so if something happens again I can take it apart easy.

Well it’s out but I got to fix the pipe now. It made it all the way to the tank. It’s probably 3.5 feet of pipe to make it that far and 2 45S silly. I will use 2 fermco to put it back together

I’m wondering if I can snake a wet dry vac Line down the hole and get it to suck it up

No fermco(rubber boot) they are all glued on. I just can’t beleive the thing went past the 45at the top. It may have 5-7 gallons of water in it. I could cut it use fermco to put back togther. I hate to take off commode as to don’t have any issue but I bet I will once I take it off.

Luckily I cleaned out the tank last night so it’s only got one bomb in it now lol it’s a plastic wand so no magnet. How deep are the tanks?

Well this morning water was froze when I went to flush. I pushed paper down so flap would close and on the pull out the brush caught the side and slipped out of my hand and down the poop shooot. I wouldn’t think it would get past both the bend but as I looked down I don’t see it in the first...

Those are the ones kind of. Mine needs a 90 fitting on one end. The ends are big you can turn with the hand. A true faucet line has a small 3/8 end that tightens to the stop valve with a wrench. The plastic end is 1/2 inch