Recent content by JanAndBill

Another update. Went back with the reinforced roller using the original mounting method(3 #12x1" screws). It works but it just doesn't seem strong enough for all the weight. I'm going to drill through the plywood and use a through 1/4 bolt and reinforcing plate on the bottom.

Different models, different years, different rollers. The Heartland # on roller for my year model is 11963, manufactured by Cass Hudson, their number is FWF-0039-10. Per Cass Hudson, they discontinued this roller at the end of 2013. The new model would likely work, but it IS NOT a direct...

Update: after scouring the internet for a replacement roller (see post 12 above for picture) with no luck, I called Heartland. They don't have it, but did give me the part number and manufacturer. Called them to find that they had discontinued the part at the end of 2013. I suspect over...

Yup that's it, mines broke in the same places. Guess the simplest solution is to weld and reinforce my old one, and pack some grease in the bearing. I need to really look at the others, because this is the first one to break, on a 2013. However, I've noticed the past year it seems like the road...

Managed to get my roller out. Fairly easy once I got the wood trim off. Still had to remove the drawer under the the refrigerator to get one of the screws. The bracket is cracked/broken in three places. I can weld and reinforce it if I have to, but the ball bearings in the roller are a little...

Is it only stapled at the back? And how did you reattach?

The kitchen slide with refrigerator is scraping the vinyl going in and out. It appears that the bracket on one of the floor rollers is making contact. I can reach under the front and wiggle the roller, so either the pin has come out or the roller center hole is worn. It appears that these are...

Changing the temperature setting works for a little bit, but then does the same thing. Haven't had a chance to check the temperature differential, but I'm leaning toward that as an issue.

I would think its possible if just the compressor was cycling, but it's not. The fan and compressor both cycle on and off.

I need to check, but I believe when I reset it, that it defaults back to d1. I need to recheck that.

On auto during the day, it will cycle off (fan and compressor) when it reaches the correct temperature. Depending on ambient temperature it miIght stay off 5,10,15 mins or so before it will kick on. Of a night it drives you crazy with the ON/OFF routine every 2 or 3 mins. Is there a way to...

Already tried it. Didn't make any difference.

We recently bought a used 2019 trailer, with Dometic air and a single zone Dometic thermostat. On "auto", during the day, it seems to do okay, but of a night the fan and compressor comes on runs a couple minutes, then shuts off. Couple mins later it will kick on again, only to repeat the...

Sometimes it's better to think it over, before you start. 4 hrs home today, backed under the cover, and unhooked. Out of curiosity I hit the switch on the jacks.....worked like a charm. I hit some really rough sections of road on the way up.

I've done pretty much everything over the years so repairing myself isn't an issue. Time unfortunately is. To many projects on my plate for the next few months.