Recent content by Michaellallen

I grounded it and all three came on. Inside lights (4 in a row) outside welcome light and awning light! So where/how do I look for bad ground? Keep in mind these lights flickered first 15-20 minutes so could be short in wire but where does the ground wire for this circuit start? Is there a nut...

All other lights in rv are working properly. Just the three circuits that are at the door on three switches. All thre are getting 12+ volts and the wire to the first led in the series is getting proper voltage. I’m not an electrician but does this indicate a short in the neutral? If so, can it...

So we were camping and plugged into shore power and our main lights started flickering. Then they just stopped altogether. I started investigating and found that not only did the the main led lights stop working but so did the outside welcome light and the awning lights. I found that the 3...

That makes sense! Thanks for the respises Sent from my iPhone using Tapatalk

So this frass keeps showing up in my out door “party center.” It seems to be of the same consistency at the old house borers that get into my deck. I can’t see any holes in the door or anywhere obvious, but when I tap to “ceiling” area (would be under the bunk) of the party center, some falls...

Something to think about. Hopefully two won’t blow at same time Sent from my iPhone using Tapatalk

I did add the 2x4s and drilled the jacks, put screws in so I don’t have to worry about separating the jacks and blocks. I wish I could find a diagram of the framework under the slide. What happens and the reason for the jacks is that when setting up I get camper level and the put slide out, the...

I want to put slidewinde slide supports under my big speed out (m32) should I put them on the edge of the slide outs? The flooring is so ridged I don’t really know where the rails are. Can’t find a diagram. Thabks Sent from my iPhone using Tapatalk

So I checked voltage and got 120 from breaker to unit. On the 4 way switch I was getting 120v on each of the 4 legs when I turned it to low fan or any “on” position. Nothing working, no fan, no nothing. Any idea why the control knob would put power to each leg? I though it should go each one as...

After looking at the end and seeing the romex I figured it wand a ground after all. Thanks for clarification. I will check voltage and report back! Thanks Sent from my iPhone using Tapatalk

Guess I will have to take it in!

Never mind! I got smart Sent from my iPhone using Tapatalk

So now I’m a mallard owner! Really excited and I’m set up in the driveway! Can’t figure out how to turn on led lights on the awning. I have the remote but can’t get anything to come on. I replaced the battery and still nothing. Do I need to point the remote to a particular place? Couldn’t open...

I am buying a m32 on Saturday. This will be our first new tt purchase. I know we do a walk through but I need to know what specifically to look for before I drive off the lot. Can I run hot water, check power awning, check for leaks? All this stuff, I just don’t know what specifically to look...

I am planning on buying a m32 Saturday in Raleigh nc. This will be my first new tt and need some pointers. I know that I get to do a walkthrough but no idea what to look for. Will they hook up water, test ac, fridge, water heater, greased axles? What do I need to be looking for! I want it right...