Search results

Looks like my 2013 Elkridge 34QSRL water heater has decided to leak. Is there any experience or suggestions for going tankless? Sent from my SM-G960U using Tapatalk

I ran 80 in mine. Discount tire prorated 77$per tire. I actually had an opportunity to move to 18" rims. The 18" tires get a higher load rating which i hope will help. Went with the Michelin a/t's this time. So we shall see. Thanks for your post! Sent from my SM-G960U using Tapatalk

35000. Not exactly worn out yet. However, the outside lugs on all 4 are almost down to the wear bars, center ribs have lots of life left. I run 80 psi. Near gcwr when towing. The geolander has a slightly higher load index than the Michelin . So was wondering if those would wear better. Sent...

Time to replace my Michelins. Did you go with the geolanders? Sent from my SM-G960U using Tapatalk

Our 2013 elkridge kitchen grey water tank dropped and was resting on an axle. I suspect the 'thin' angle iron had bowed previously and the tank had been riding on the straps for some time. Then a strap broke. Wish i had thought about unistrut while i was under there! I replaced the broken...

Does anyone have any pointers or have success with the ReserveCalifornia website? Have been trying to reserve at silver strand SB in San Diego. I realize this is very high use and hard to get spaces, however, I was able to get reservations when it was on ReserveAmerica. this morning the site...

In preparation for retirement, we are looking to upgrade from our 2013 34qsrl. However, if the workmanship in the landmark is anything like that in the Elkridge , we will most definitely look to another manufacturer. We recently experienced the kitchen grey water tank coming loose and landing...

Great, thank you! Sent from my XT1585 using Tapatalk

Is there a kit or any recommendation for replacing the weather stripping on the slides? 2013 34qsrl. Mine are falling apart. Thank you Sent from my XT1585 using Tapatalk

Looking for recommendations for brand/model to install over bed. Would like as quiet as possible. 2013 elkridge 34qsrl. Thank you Sent from my XT1585 using Tapatalk

Thank you Sent from my XT1585 using Tapatalk

Hi folks, We are looking for a place to park our 37' elkridge between July 17-22. We are staying in Vista a few days prior to attend our Grandson's graduation from the sea cadets training at Camp Pendleton and are coming back to silver strand the following week. Just trying to eliminate 1 trip...

reservations are made:) This will be our 1st trip out since Quartzite! Looking forward to the cool pines.

Hi Garry, OUTSTANDING! The rally was! Thank you for hosting and all of the hard work you and everyone else did getting the potluck together and the rest of the activities. Kathy and I had a great time and are looking forward to another. Thank you very much, See you soon,

Hi folks, Welcome to the AZ Chapter! We are looking forward to meeting you in Oct.

4000 miles, 2 weeks and 9 states later... Great trip, the QSRL did very well. Only one issue with the blackwater valve malfunctioning. and that was able to be worked around with a stop at camping world!

I would be interested in comparing notes with you. We also have a 2013 34QSRL that has been back to the dealer several times over the past year. We just had the kitchen slide ram and the hydraulic pump replaced. hopefully that was the last time we will have it in. Starting on a 2week, 3600...

Thank you for that. I think we may stay a night around Klamath Falls to breakup the trip. We should be there evening of June 2. What is a good spot for an overnighter?

We are looking for a good route from BM to Crescent City with our 37 footer. Mountain roads are not a bother but am looking for better time and less fuel cost. Good sams route planner takes us through Oregon on 140 and then 199 south. I am wondering if it is better to take I80 to I-5 and over...

Welcome Tom and Fran. See you in October.

Craig, you restored my confidence in your company. You went above and beyond to satisfy an extremely disgruntled Heartland owner. The Factory would not authorize replacement of the Hydraulic soaked belly pan so you took it on yourself to replace the bad portion. You also detailed the rig prior...

I have been through the Carlin tunnels 100's of times but did not have to pay attention to the height. My guess is you are ok as NDOT requires a permit over 15'6". I understand the truckers atlas will give you that info. It should be found in walmart.

Good times Garry. Thank you for the hospitality. Kathy and I are looking forward to the next one:) And it was fun meeting our new friends!

I had mine shipped free from suspension connection for $276. Piece of cake to install, I carry a small 12v compressor and fill them up after I hook up. On board compressor would be nice but I don't find it necessary.

Update: After 16 days at the dealer, finally get a call saying that they have auth. to replace pump and kitchen cyl. However, they would have to remove the belly pan to get the s/n from the cylinder because HL does not know what cyl. they put on the coach! That would mean at least another two...

I had a similar thing happen recently. Picked up our rig in January and the bedroom slide was most of the way out, and the kitchen was part way out. The batteries were disconnected. It has been in the shop for 3 days now and they have ruled out the pump. On the 2013 Elkridge, there is not a...

Thanks for checking it out Garry. Will see you in Elgin:)

Thank you all, It will be going 'back' to the dealer tomorrow. I guess it was wishful thinking that we finally had all of the bugs worked out

Picked up our Elkridge from storage a few weeks ago and found the bedroom slide almost all of the way out and the Kitchen was part way out. The batteries were not connected. Is this normal from sitting?

Has anyone been to the little rv park in Patagonia?

Yes, we are looking forward to meeting everyone. We have stayed at Quail ridge, it was fine.

Kathy and I will do our best to make it to Elgin. Love the area. Glad you have started an AZ chapter. Count us in!

Wish I could have taken a picture. It had the smaller cutout and was very well done if it was not factory.Thanks for the reply. I will keep looking. I damaged my tailgate and will probably have to buy one of the louvered gates.

I was recently in south Texas and saw a dodge ram with what appeared to be a factory tailgate with a cutout. Has anyone seen one of these? I am wondering if it is a custom job or if you can purchase these? thank you

We replaced ours after the rig sat in the lot at the repair shop for three weeks waiting on parts. They called me to pick it up and 15 min later called back and informed me that two of the tires had separated. Probably had less than 2k on the treads. Purchased Michelin LTX's. They ride better...

Yea, bit the bullet, not a question there. It was a surprise to have to do it so soon!

Having read all about the towmax tires, I have religiously maintained the air in the tires prior to departing everytime and checking them on the road. I also purchased an air compressor to handle the task. Now while my trailer was at the service center for more warranty work, the service...

After reading about all of the tire issues, I waited for Discount tire to open before we left on our last trip and swung into check tire pressures. Sure enough, had a leaking valve stem. Definitely need to check the tires every time!

I have a few hours before the reservations start for March. I am looking at either San Clemente or San Elijo for lack of knowledge of any other places. Since we are new to this, I want to make sure I get a long enough space for our 34' Elkridge and tow vehicle. Is there anyone with any...

Well, after a week at the dealer.... this is what they came up with,, there was a gap between the vent pipe where it goes out the side of the trailer. Their thought was the odor was coming back into the trailer via this gap, so they sealed it. No studor valve is installed in the coach!! We...