Search results

Just something I'd like to share with the group. If you tow with a Trailair Flexair, you may want to check the bolt shown in the photo. I have found it to be loose on two occasions. The first time was purely by accident. I happened to see some daylight between the washer and the body of the...

We are boondocking just outside of Fruita, CO about 12 miles from Grand Junction. We will head to a state park for the weekend to do some laundry and stuff. Then head into Pueblo on Monday. James and Sheila

In regards to the lights pointing up with the trailer attached. The leveling kit that was installed will actually increase that problem. Your truck has rake built into it so that the truck sits level or close to it, when a load is applied, dropping the rear end to approximately where the front...

We use WEN 3100w and 2000w inverter generators in parallel with a WEN Parallel connector. The connector has (2) 30amp outlets so you just plug directly into it. We can run our 15k a/c , the tv, sat receiver, the microwave and res refer, not to mention a few small loads i.e. phone chargers, clock...

I would have to agree 100% , the LED's are well worth the money. I also love the tow tech bundle, although I do shut the lane keep assist off.

Re: Considering 2018 F450 Lariat Ultimate Jim, ours is the platinum with every option available except spray in bed liner. Price on the windshield was about 94k and we got it for 77k. So your numbers are pretty doable. I do, however, think we were helped by the fact that our truck was ordered by...

Jim, the turning radius in the 450 is ridiculous. I swear it turns inside what some cars can turn. We love ours....... Sent from my SM-N910V using Tapatalk

We use the WEN 3100w and 2000w used in parallel. Easy plug n play parallel cord by WEN and can run 2 a/c's if needed. I can also just use the 2000w if no a/c is needed. Have had zero issues with the pair of them, always 1st or 2nd pull. Wouldn't hesitate to purchase them again. IIR they also had...

You can also check out http://www.santeelakes.com/ for storage. I have no info on rates or availability but know that they have secure storage.

Lol. Thanks guys. I do have a pretty healthy impulse buying habit. This was no impulse though. We have been looking far and wide for the right truck and this one "fell" into our hands. On a sad note, first full day towing with her and a rock took out the windshield. Sent from my SM-N910V using...

We had a few problems that we couldn't overlook. When going downhill I would have to hit the gas to get the rpm's up so the exhaust brake would work. Kinda hairy on a 7% grade with no guard rails and 2000 ft drop offs. Back and forth with Dodge, told its working as intended. Long story short...

Thank you Jeffnkelly

I will say its quite the surprise when you are driving down the road late at night in a new truck and the wife hits the seat massage button. I didn't even know we had that option. lol

Thanks, Had it not been for the way we were treated by Chrysler Corp, we would have never known how nice the Ford was. lol Thank you Jerrod, I was never very brand loyal, just want a truck that will do what it is supposed to. We will be in this park in Cody, WY for another week or so then we...

So Sheila and I are driving down I-90, just minding our own business. We stop in Bozeman, Mt for fuel. As we are driving through town to get back on the highway, we pass the local Ford dealer. We have been very unhappy with our Ram and how Dodge Corp handled issues so we had test driven a '17...

To circle back, the rebuild kit did fix my tank filling issue. Got lucky I guess.

Sheila and I will not be able to make the dinner but we will be at the meet and greet. She will concoct some sort of appetizer/snack/dessert thingy! See you all there!!!

I checked the pump per user guide instructions and as far as I can tell it is fine. Will try the rebuild kit and go from there. Sent from my SM-N910V using Tapatalk

Well, woke up to water all over the ground this morning. Anderson 4-way valve is filling the tank while on city water. Called all dealerships close to me in So. Cal. and nobody has a rebuild kit and some didn't even know what I was talking about. I called Anderson Brass directly and talked to...

I wish it were as simple as the master switch. Still no luck on the basement lights. Unfortunately or fortunately, I am packing up now to move on to our traveling portion of full timing so I wont be able to address this until we get to Mesa, Az. I'm hoping it turns out to be something simple as...

OK. Update. Found a wire nut that a wire had escaped from behind the basement wall. That got me everything except the basement lights. Sent from my SM-N910V using Tapatalk

The light in hitch area is also out. So whole front of trailer Sent from my SM-N910V using Tapatalk

So Dan is correct. Udc light out as well. Will double check all fuses and possibly under bed. Don't think anything would have come disconnected as the bed slide hasn't been moved in some time. Will report back. Thanks for the ideas. Sent from my SM-N910V using Tapatalk

Same when I take batteries out of series and check separately Sent from my SM-N910V using Tapatalk

13.3? When off shore power Sent from my SM-N910V using Tapatalk

ok guys here's my problem. The other day I noticed that my 12v lights in the basement would not come on. Also noticed that the light in the battery compartment isn't coming on. Last night noticed the reading lights above my bed are not working. Not sure where to check now. I checked the mini...

I had a 2013 Ram DRW with leaf susp and moved to the 2016 Ram with air leveling. Though it was a bit different feeling I wouldn't say it is a significantly smoother ride. YMMV. The rest of the 2016 truck you may ask? Dont even get me started....we are looking at ordering a 2017 F-450. That...

Our fireplace quit working about 2 months after we bought our LM. It would turn on, then about 15-20 seconds later would completely shut down. Figured out that it was the overheat protection due to the blower not starting. I took the unit out of the cabinet and noticed the blower wheel was...

Just shy of two weeks in Branson, Mo. With the back of the landmark on the bank of Lake Taneycomo. Then a run north on the "million dollar highway" through Silverton, Co. Great trip.

Agreed! I had to drop a portion of my front section due to a pressure tested black tank (don't ask) lol and am unable to get it back up to my satisfaction. Seems to have stretched it and it doesn't fit flat to the frame now.

Re: Leaking Level Up Hydraulic Line Help! I get what you're saying, I hate the cold. As far as the safety factor, I figure if all the legs are retracted fully, the trailer can't go any lower unless the the axles fall off. I would never lay under it with extended jacks being the only support...

Re: Leaking Level Up Hydraulic Line Help! I just replaced an elbow fitting for the LF landing gear at the manifold last weekend. I also did step 1 in connecting my trailer to the tow vehicle. Everything went great but then I realized after finishing that hooking up the truck was a step I...

I recently noticed stress cracks in my rear cap at all the ladder stand-offs. I don't use the ladder anymore, just use my folding ladder to lean against the top of the stock ladder.

Re: Bighorn. NAME Well said!

Is it Oct yet? This winter thing sux

Re: Bighorn. NAME You can park your BH Traveler next to my LM anytime. I'm more interested in talking to you than your trailer anyway.:p BTW welcome to the group!!!!

We ordered with the recliners. After about a year they were falling apart and frankly we were tired of spinning them and strapping them down before travel. We gave them to the kids and bought a residential power reclining love seat (theater seat minus the cup holders and storage between us)...

Our credit union doesn't have a specific rv loan but will do a personal loan with collateral for 15 years max. Unfortunately their rates are a couple points higher for a personal loan vs. an auto loan.

Thank you very much! Sent from my SM-N920V using Tapatalk

What time is potluck? Sent from my SM-N920V using Tapatalk