Search results

I've got to take it out and look. It's all started when I noticed a small drip leak coming down from the bathroom over the wheels. I went to flush the toilet and the waste ball dropped down. As long as I'm in there I might as well replace as much as possible.

Thanks! That's good info, I may need to get the valve too.

Thanks! Probably the same, need to pull my SXS out before I can get back in the bathroom Did you find a good source for your parts?

Need to rebuild the porcelain toilet in the garage and don't know what kit will be needed. I don't see any info on the toilet itself. Any ideas on where to start?

The Trombetta solenoid fixed the problem!

Amazon $49, one on the way Just noticed after I ordered it they dropped to $38. If I wanted to wait I could get one off ebay for about $25, or take off for $18 ...lol, go figure!

The Trombetta should stay open until a switch tells it to close and route power to forward or reverse. This one is staying closed full time (both terminals hot) without the switch telling it to close therefore sending full time power, running the pump until the breaker kicks it off.

I believe it is the Trombetta. When I talked to the first tech he ruled it out but I wasn't convinced. The pump goes on when switch wires are disconnected from it and both terminals test out closed full time which they shouldn't, therefore not disconnecting power. I have one on order. More to...

The Trombetta is the 2 way solenoid. I now need to test the voltage to the valves

Of course! I've been on the phone with Lippert tech support several times and they are scratching their heads at the moment. They said if I couldn't manually retract them it would most likely be a valve or low pressure. They retracted so that I believe is ruled out. Now to get back to them with...

The A/C electrical issues was merely the GFI on the inverter wasn't reset, everything seem to happen at the same time but as I can see now, shouldn't be related. The batteries are good. The switch was properly disconnected and re-connected to rule out the continually running motor due to bad...

Two different issues, got the A/C power from the inverter figured out. No battery/power issues found, I also ruled out a bad slide switch as I pulled all wires from it and still same. I was able to manually retract the slides by turning the hex head clockwise on the manifold and using a hex on...

Get a clicking sound from the jack solenoid but jacks wont come down, now the main slides won't retract and the fridge which is the AC/DC only type wont come on that runs off batteries. Batteries show 12.6 but thinking it might be the load. Any ideas?...lol

Do you mean these?

Can't find info on how to easily remove the 4 season door. Can't fit our SXS through it. Anyone with experience?

I see that there are only 2 screws on the back bottom part of the frame holding each side down. But getting to them is another thing, not enough space to get my arm in to even use a ratchet.

Help..🤪 Scratching my head while and getting my hands and arms stuck trying to get to the screws that hold the couches in order to remove them. I can't gain access to even get my hand in where they are let alone a screw driver. I must be missing something. Any experience with this would be well...

Geez, kinda disappointing to hear they have such an issue with these being a "top of the line" trailer. Sounds like you did and going to do a top job. I'm a bit surprised as well they don't have an awning over them however that would be a lot of awnings and wouldn't protect the sides much. I'm...

Just want to makes sure everything is sealed up tight on all slides so water can't get in at all.

Being in the PNW, I would like to get this addressed asap..... If anyone has more pics of their fix would be greatly appreciated!

Thank you! Always nice to have a good forum that's supportive to the interests. I'm sure there will be things I'll need help with or questions about. - - - Updated - - -

Thanks much LBR! ;)

Thanks! Been waiting many years (decades) for something like this, was able to buy a CAN AM X3 SXS a couple years ago and been hauling it with a truck/camper and flatbed. That was fine as a bachelor, however now that I found my other half this will be so nice. Still might keep the 11.5' Arctic...

Sounds like you had a lot of fun and great memories! Yep we were looking at about $10,000-$12,000 more for the same trailer here in Oregon.

Thank you! Always nice to have a great forum that relates.

Just pulled the trigger and we bought this 2018 Cyclone 4005 Couldn't find one in the PNW, or one we liked, or for the price so we shopped and found it 2000 miles away. We did our due diligence going through the unit and felt it will be worth every dime of the $3600 transport fee. Nice to...

Hello all! About to pull the trigger on a 2018 Cyclone 4005 We were referred here by a member of a SXS forum. We are mostly boondockers jumping from a truck camper and flatbed to this beast. I've pulled many trailers and a 5th wheel race care trailers but this will be a whole new experience. We...