Search results

Jim, Claudia, and Smudge will be attending 6/23-27 as SOBs, but then again there's always hope...………………………….

Jim and Claudia from Michigan would like to attend if Oktoberfest is cancelled will there still be a Heartland rally in Amana? thanks

Just found out today the normal gate we have used in the past to enter the campground is closed. They asked us to use their new gate (Gate #2) which is just past the old one, I assume on the same access road. We will be arriving on Tuesday (10/1), using our P/A for the two days before the rally...

Thanks Bill... yes, I did look at the fuse end....5 Amp 125 volt, but it didn't specify GMA or GDC. I have a GMA in there now.....so far so good. Must have just been an anomaly or something. Sad that Dometic couldn't tell me anything.........

Does anyone know which type of glass fuse (5A 125V) is used in this unit?? Not sure if it's supposed to have a GMA 5A 5mmX20mm fast blow, or a GDC 5A slow blow? After resetting the GFI from an apparent overload, I noticed the unit would only run on LP, not A/C. Further troubleshooting revealed...

Big storm approaching the lakeshore where we live. Trailer all packed ready to go but waiting out the storm until 2PM

Dave, booked today for arrival 10/2, leaving 10/6 for Fisherman's corner COE overnight on the way back. Awaiting curbside booking confirmation sometime in August. Please add us to the list. thanks Jim & Claudia Holland Michigan - - - Updated - - - Hey Bill.....you don't drink beer, do...

Does anyone know how to adjust the flapper on the bottom of the left lower door so that it glides into the guide plate without having to slightly lift the door so that the flapper pin falls into the guide plate? Searching the forum, there was a post by Dan in 2012 about a new guide plate, but...

Just stopped by the campground today after visiting my brother who lives in Jennison. There were a good number of campers there and also a good amount water in the river. The river was very high and the owners put an extra ramp just to get to the office. Very nice folks. We did not see any...

We have a complete set (front and rear) of Lippert JT Strong arm stabilizers. We have a new camper that has hydraulic stabilizers, and can't use these any longer. $100.00 Jim 616-566-4164

Thanks Marc.....I will call the selling dealer now that I know what it looks like.....or I might get one at my local big box store and be done with it.

Thanks.....the two valves on the top of the manifold are for the leveling jacks. The valve on the bottom is for the slides. The master landing jack contains it's own valve which is between the walls and on the blind side of the rv way up at an arm's length. Not an easy maneuver to get the 5/32"...

Just wondering for anyone else that has the Lippert 6 point leveling system, how many manifolds (trombetta) do you have? My 2019, 31RLK Elkridge has only one manifold. A conversation with Lippert claims that there should be two manifolds.....one for extend, and one for retract. If you look at...

Another thing to check.....Thanks for the tip!!!

Is Heartland or the dealership responsible to provide the drill adapter? I did not get one in my blue bag. Can someone post a picture of it so that I can get one?? Thanks

Odd......I didn't get the "drill adapter" in my blue packet of my 2019 31RLK......... Also, the Lippert service guy recommends opening the slide(s) valve first, (then closing the slide(s)), followed by the leveling jack vslves (in unison), and finally opening the master landing gear valve (if...

Gary.... Don't think we will need your old window. THis camper came with a clear window unlike the "frosted" ones in our previous Heartland's, The screen door actually has a black shade as well for privacy. I think we will leave this "clear" window in, as it's the only view to the outside since...

Thanks for the research, Dan. I wonder if the new Trailer King RSTs are an improvement over the older ones, or do they just classify the tires without any suffix (RST) which explains zero complaints? Those are only the complaints that people take the time to make. I'm sure there are many other...

Just great......My 2019 Elkridge 31 RLK came with brand new, shiny Trailer King RST tires! I'm just so thrilled that I now have to spend another several hundred dollars for new Sailuns!!! Yes, at least the wheels ate 3750/110 lb. rated. I feel better already........

Hey Gary..... I might buy your old window that doesn't fit if my old one doesn't fit either. Can you get me the size of your old one??? Thanks

Just curious, if you are getting S637's at 235/85/16, what price including tax did you find? I will be getting the same tires. Thanks

Thanks Dave.......I'll look under yours at the National. Sad that we all should/need to do these "enhancements", but that, among other "improvements" were what I budgeted for when I picked out this level of trailer. It seems even on the high end/6 figure units you need to do almost the same...

Just wondering, being proactive, by getting angle iron etc welded to the hangers etc. before they brake, Will this void any warranty on a new 2019 unit? Hate to wait for them to brake in the middle of nowhere, if I’m even lucky enough to notice it before damage is done. I don’t carry a portable...

Thanks Dave for the research on the old thread, but it seems like there has got to be an easier, less expensive way to do this rather than running additional hydraulic lines or something. There was mentioned in the posts about putting a 2X4 in the slide to trick it from opening. Wonder how that...

My current new Trailer Kings have a total of 122 miles on them from Elkhart to dealer, then to my home. They have a DOT code of May 2018 on them, which makes them almost one year old as of this date. Scary to think that another 100 miles or so, and another month to the National Rally may not...

Not that we need to get back there every day, but wouldn't it be nice to have the OEMs add this at the factory??? Those screws seem to never go back in the same place once you remove them

Also wondering what other load range "G", 14 ply tires are out there (besides Sailun) that are any good????? Haven't heard of "Provider" either

Wondering also, with a single (hydraulic) slide switch, and no way to "valve out" individual slides, according to Heartland customer service for my unit, if it's possible to isolate, either electrically or mechanically the logic of which slide open, or stays closed first. On my particular unit...

Sorry also to hear of the blowout/damage, not a FUN THING!! I did not see mention of how old the tires were. as I didn't see what year trailer you have. Nevertheless, my new Elkridge has the infamous Trailer King, load range F, 12 ply tires on it from the factory. Hopefully, my wheels can handle...

That's a really good question, as we "thought" is was smaller, but if you measure tip to tip it's the same. It definitely has less storage than the Gateway. On the drive home yesterday, it seemed lighter, compared to the empty Gateway. The GVWR is 500 lbs less also.

Just took delivery yesterday on our 2019 Elkridge 31RLK Adventures and fun are hopefully ahead!

Goodbye to my 3200rs 2014 YOU have served us well and brought us safely to fun destinations. may you give the next owner the same experiences! enjoy the disk brakesi put on! picking up my 2019 Elkridge 31 RLK TODAY

.....Not to beat a dead horse, but "gary521's" response hit the nail on the head. It sounds like he's familiar with the 80/20 (Pareto) rule! Here in the Nuclear Industry, I've used Pareto charts during Common cause, Apparent cause, and Root cause analysis many times, among other causal tools...

Congrats on the 31RLK We just bought the same one, and are picking it up tomorrow from the dealership. We had a great PDI, and hope we caught everything that we could, until we start down the road. What options did you get??? We got the 2nd A/C, and the non-residential 12.6 (?) cu' Dometic...

.....Just wondering if I40 is still under construction, fixing after all the rock slides in SC, Tn. etc. We were at our other house in Chapin, S.C. a couple of weeks ago, and the drive from our home in Holland, Mi was terrible through that area.

Because you have never met a negotiator like me just ask my car dealer last January when he almost gave me a brand new car

Very nice, then can I assume my Elkridge manufactured in 5/8/2018 went through the new audit facility, or was that too early? Thanks

Welkom as well, from Holland ,Mi. Tell us about your trailer.......................

Speaking of "rallies", is there a way to get past rally stickers? We are trading in our Gateway, and I don't think I can peel off the present rally stickers without damaging them. I need. 2011, 2013,2014 (Urbana),2015 (Shipshewana) ,and 2017. See photo. We will be at the National rally in June...