Search results

Wanted easier access to gray tank valve.I cut all the way across plastic behind sewer pipe.I used a piece of uni-strut across trailer frame above edge of frame. I attached a piece of plastic divider used between lattice panels to uni-strut. After trimming plastic underbelly was able to slide it...

Having issue with maintaining level over time.Parked in driveway at home left front wheel is about 1 3/4" off driveway when level.After 10 days or so the wheel will be on driveway. Using auto level it picks left side till level, front to back stays OK So far I have replaced valve on manifold for...

I can smell propane in camper, alarm has not gone off.the first I noticed it was in compartment for door side tank but now can notice it in trailer but seams to worse in door side compartment. I have replaced the pig tails for tanks,checked all connections with wrench and a spray leak detector...

Our kitchen faucet is is a brushed nickel finish that is going bad starting to come off looks like chrome underneath finish. Has any has anyone redone finish? What did you use? Looks like a sprayed on finish over chrome. Plan on removing faucet to refinish counter tops will replace if I can't...

Just some info that may help someone. Lippert changed my level up to 6 point from original 4 point 2 years ago,did a good job. They had to change pump and they installed an 80a manual reset. The 80 would trip in low temperature,below freezing,when using auto retract but not with any other...

Removed oven replaced with sealed burner stove top. With convection micro oven was being used for storage. Removed oven to make a more usable storage area. No mos needed to install stove top fit existing cut out. Grates for burners have to removed to install counter top covers,made space in...

Those that have replaced it,what have you used? Mine just went bad has worked well till now.Looking at Shurflo 4048 also Flojet r4525743a. Understand Flojet is quieter and more even flow.

I am replacing the bottom seal on kitchen slide. The seal is EK seal it is the wiper seal with a track for D bulb seal and I am replacing both . Has anyone done this? On the wiper seal there is an adhesive strip and a lip on one side. On old seal the lip had kept the adhesive strip from sealing...

Looking to replace furniture in 2011 Grand Canyon. Flexsteel makes several that fit in back under window. Looking at model 4212. Any experience with Flexsteel do/did you like,quality? Not being able to actually try it before makes me hesitant. I only have 32" depth so selection is limited. Thanks

Kitchen slide rear corner. At location where bottom seal and side seal end they are tearing and floor is damaged. Floor damage is where floor roller travels and at end of travel when slide is in. Roller seams to be OK but can hardly see it. Slide looks to be close and open properly. Have some...

Water heater tripped breaker checked element first by disconnecting element and the resetting breaker. Breaker held so I thought problem was with element it is not usual for bad element to trip breaker but it can happen. That was not my problem. With futher checking had no voltage,120v, to...

The fan on convection has started making a noise like it is hitting something. Has anyone else had this? Fixable or just replace?

Have a question not sure if it should be here or in elec. Level up has started tripping breaker when retracting jacks. I have the level up on it's own circuit w/70a manual reset breaker. Checked with amp meter 55/60a when extending 65/70a when retracting spikes to 100a at end of cycle in auto...

Has anyone replaced any of the cables? I have 1 that is starting to fray at end. When camper was new the outside bracket pulled off slide due to screws being broken when installed . Dealer moved bracket up to be able to install new screws. At Goshen the factory rep said that was a problem to...

We had a Dometic 1350 in camper.Have not been real happy with it all though it is working properly according to Dometic.After talking to several people who have changed to residential units decided I would give it a try.I installed a Samsung RF197.The Samsung is 3/4" narrower than 1350 and about...

Truck fire this morning has caused 81 N to be closed at Harrisburg Pa They say it will be least thru weekend but not sure at this time.Tolls are being waived between Carlisle and HBG East on Pa Turnpike.Just a heads up if traveling that area.

1350 ice maker and WID stainless steel.I am replacing with residential unit.Was new in 11/2010 is working and still in use extended Dometic warranty.Will be in use till 5/22.If interested PM me.We are planning on going to National rally may be able to bring it.

Over this winter noticed exhaust fan in microwave did not seam to be doing anything.Checked from outside and flapper on vent at back of micro was not coming open.Seamed to be blocked.Waited till home and pulled micro. vent was to low for opening in camper.Trimmed about 1/4" from top of vent...

Installed a aux tank in bed.Tank had mounting tabs on bottom and at top that lined up with top of bed rail.I bolted to rail and bed.Bed sheet metal is tearing at front corners.I also have viberation issue that I am told they all have.Took to Ford to see what they say.They say problems are...

I have been having an issue with the doors.When you shut the right hand door the left side would open a little just enough to lose seal around door and temp would go up.Talked to several Dometic authorised repair centers.They either did not want to look at it or would tell me was an issue with...

Having a problem I have not seen before.Turned it to propane,preparing to head south.Burner would not lite it tried but would flame out around tube.Found usual bug nest and cleaned it out.Turned it back on nothing would happen did not try to lite.After checking fuses and voltage seamd to be OK...

Ours had just stopped working recently.Had been having some issues with it since new.At times would have to enter code more than once just thought it was operator issue.Since it stopped completely thought it was battery in sender.When I got it apart found battery holder cracked at solder...

I pulled the heater vents from floor to repaint.Looking into belly I could see hyd. line and elec wires in belly.Started looking at where they ran noticed hyd. was wrapped around webbing of frame cross member.Could not see real well but could feal where it was rubbing.Not sure it would ever be a...

Just a heads up.I have the electric cable operation for the bedroom slide.Arrived at campground this afternoon went to put slide out about half way it started to sound like it was in a bind never any issue before.Went outside to check make sure was not hitting anything and look for issue there...

Prior to Gillette rally we will be going from Grand canyon to Bryce and then Yellowstone.I was planning on using E entance to Yellowstone.all new territoy for me.Suggestions for route appreciated.I was planning on 3 days travel from Bryce to Yellowstone.I am sure GPS will get me there but not...

A/C and heat not working.Can just make out digital display on thermostat has E1 code.Have tried shuuting off all power no help. Display is allmost unreadable.Anyone have similar problem or ideas.Manual says loss of communication but no other info.Thanks

I am planning on having Mor ryde IS installed.Considering having bearings done also.Many conflicting issues on different fourms.Mor ryde says they are not a problem and a good upgrade problems in past have been solved.Any experience w/these.I am still able to repack my own so maintance is not a...

At a seminar today put on by Titan Brakes.Presenter said Heartland will now install disc brakes if customer wants.True?

We are at PIR now see many Heartland campers nice Heartland display in camper sale area.We are in row 3 lot 164 will be a cold one for anyone interested.Plan to stay In Phonex area for April then head to Grand Canyon,Yellowstone then rally at Gillette then east to Rushmore back in Pa by Aug.Our...

On our level up after setting up using auto level we have to disconnect all power to level up before being able to use level up again.I cannot find a wiring diagram for system.I would like to put a switch in 12V supply to level up control.There is a wire from main power to pump it goes to unit...

Question for those w/slide toppers.How do you clean and treat outside seals along top of slide under topper?I just tried w/long pole and paper rag and silicone.I know it did some good not sure how much.Thanks

Leaving tomorrow heading for Bushnell Fl..Going to meet with some friends for Dec then head out again not sure where,Texas maybe, but will plan as we go. If all goes well will be at rally in Wy. in June then head back to Pa.Snow should be gone!

We are not fulltimers.We spend 5-6 months of year in camper about 4 months continious over winter.Every year we have many problems with USPS forwarding mail ,I have used a relitives address and they send it on to us.Has anyone used UPS? They have a store close to home address seam to have a...

Storm went through Thursday nite,winds in excess of 70mph tornado about 6 miles South.Camper parked at house pulled slides in before storm.Wind blew water in around windows of house and camper also blew fridge in camper out of opening in wall tilted in about 3" at top door came open and hit...

Have just now been able pull wheels to pack bearings,I usually do this before using camper.Camper was new 11/2010 due to late delievery did not have time before leaving for Fl for winter.Also I do not now or ever use e/z lube have seen to many bad conditions because of it.I sent pics to dealer...

Has anyone tried to move pin box up in Landmark?I would like to raise box 1 hole to get clearence for tri-glide jaw.Although there is 1 set of holes cannot raise due clearnce problem.I can get 1 bolt in each side of front row but cannot get back holes to line up.Box hits at top corner when I try...

Has anyone had the shades crack on flourescent lights?5 of the shades on ours have cracked.

The bar that attaches to shower wall,one that shower head slides on, seams to be loose.Cannot see how to take apart decorative trim.Thought i would ask before breaking something.Thanks

Truck full fuel, 2 people,crossbed tool box,hitch frt axle allowed 5940 actual 5240 drive axle " 9000 " 4060 w/camper loaded for winter trip all tanks about 1/3 frt 5320 drive 7500 cmper axles 11860 truck...

Anyone have any experience with Jensen Omni Directional Antenna?