I was reading through my manual that came with my Bighorn. It says to check and make sure the bolts are tight on the pin box but there is no torque setting to use.
Hi Bill,
When I installed my MorRyde pin box the instructions had a chart of torque values for various bolt sizes. Here is a link to those instructions:
The torque chart is on page 3 and this one won't make your head explode. The only problem I had was that my pinbox bolts are 1/2-20, grade 8 which is not listed on the chart. So, I contacted MorRyde and they said the correct torque value is 100 ft-lbs for 1/2-20 grade 8 bolts.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.