Add 110 outlet

MJordan

"PA n MA s"
Hello:
We are going to replace our table and chairs with a booth dinette.
We need to move the outlet on the large slide so it is not covered over by the booth.
My question is, can I add another 110 outlet to this one.
If we move it forward we have no outlet for the chairs, if we move it backwards we have no outlet by the table.
Can we "split" it and have two outlets; one by the table and the other towards the back by the chairs?
 

Bob&Patty

Founders of SoCal Chapter
You can add several to the existing outlet. BUT, dont overload the circuit. Unless you tear open the inside wall, you have to use "J" boxes attached to the wall. Add a "J" box over the existing one and run EMT to the other boxes to be safe. I would not leave rolmex just laying on the floor. JMHO
 

MJordan

"PA n MA s"
You can add several to the existing outlet. BUT, dont overload the circuit. Unless you tear open the inside wall, you have to use "J" boxes attached to the wall. Add a "J" box over the existing one and run EMT to the other boxes to be safe. I would not leave rolmex just laying on the floor. JMHO


Thanks for the replies
 
Top