ATF: Landmark - Hot water heater controls

harrisrf · Dec 9, 2014

I have a 20-15 Landmark, I noticed on the control panel I have a switch for the hot H20 thats labeled 120 volts and a switch that says 12 volts. Can I assume the switch that is labled 12 volts is the gas operation switch for the H20.

jbeletti · Dec 9, 2014

harrisrf said:
I have a 20-15 Landmark, I noticed on the control panel I have a switch for the hot H20 thats labeled 120 volts and a switch that says 12 volts. Can I assume the switch that is labled 12 volts is the gas operation switch for the H20.

Yes - you are correct. Labeling the Propane operation of the water heater as 12 Volt is a bit of a misnomer. I'll pass this on to the plant to see if over time, we can have this panel designation changed.

Bob&Patty · Dec 9, 2014

As far as the 120V switch never turn it on unless the HWH is full.

jmgratz · Jan 3, 2015

Bob&Patty said:
As far as the 120V switch never turn it on unless the HWH is full.

Our 2013 Landmark is labeled that way too. Guess they have been labeling them wrong from sometime now.

pegmikef · Jan 4, 2015

Our early 2014 BH has same labeling, but it was clearly explained during our PDI.

ATF: Landmark - Hot water heater controls

harrisrf

Member

jbeletti

Well-known member

Bob&Patty

Founders of SoCal Chapter

jmgratz

Original Owners Club Member

pegmikef

Well-known member

Similar threads