WiFI Ranger Go2 indoor router, Elite outdoor router and Verizon USB U620L modem install + cell antenna

And true to form with the WFR stuff.

After the above post I connected to the WFR with laptop in my office. Gave it a few minutes then opened up the router admin page.

Yep, the router was connected to the house and the router was off line to the internet and I had to click on the connect automatically button - again.

The stuff just doesn't work as advertised.

So, I connected to the Cyclone's WiFi Ranger equipment.

I went on the WFR admin page and connected the WFR to the house router,
Tap the connect button and get online.

Tapped the check updates button and now you are 'forced' to register. In the past the register page never did anything and the entries disappeared every time you reset the router or turned it off.

After about 5-10 minutes the router re-boots, shows the current firmware, tap connect and according to the screen I am connected - NOT.








A true Charlie Brown 'Good Grief'