Step by step pictorial guide on replacing our 12 gallon water heater in our Landmark

Wgmurray65

Member

• Sep 24, 2017

• #1

We recently replaced our Suburban SW12DE water heater in our Landmark. This step by step pictorial guide should make the job go a lot smoother should you decide to do it yourself. Your rig installation may be different so some of the steps may be slightly different or not apply, but the basic principles remain the same.

Please clink the link.

http://bkamericanodyssey.com/2017/09/22/water-heater-started-leaking/

 

G

Garypowell

Well-known member

• Sep 24, 2017

• #2

That was GREAT! I hope to never have to do it but your pictures raised my confidence if I do.

Thanks,

 

J

jbeletti

Well-known member

• Sep 24, 2017

• #3

Great work and great write-up. Check your anode rod twice a year

 

C

crussian

Well-known member

• Sep 24, 2017

• #4

I dont have a landmark but i would think the "10" gallon version would be close enough to use as a guide.

C&J

Sent from my SM-N920P using Tapatalk

 

TravelTiger

Founding Texas-West Chapter Leaders-Retired

• Sep 25, 2017

• #5

Thanks for sharing!


Sent from my iPhone using Tapatalk

 

carl.swoyer

Well-known member

• Sep 27, 2017

• #6

Wgmurray65 said:

We recently replaced our Suburban SW12DE water heater in our Landmark. This step by step pictorial guide should make the job go a lot smoother should you decide to do it yourself. Your rig installation may be different so some of the steps may be slightly different or not apply, but the basic principles remain the same.

Please clink the link.

http://bkamericanodyssey.com/2017/09/22/water-heater-started-leaking/

Click to expand...

I replaced mine last month. I kept the old parts thermostats, circuit board,lp module and the heating element. I put my heating element in a glass of distilled vinegar and it looks new again.

Sent from my XT1254 using Tapatalk

 

J

JMP

Active Member

• Sep 28, 2017

• #7

Bill & Kelly - thanks for sharing this information. I have an Atwood 10 Gal in my RW 427. No issues yet. But it is good to see this job can be tackled w/o taking the trailer into the shop.