yellow/orange flame on stove

aatauses

Well-known member
He everyone,
I need a few suggestions. Our stove burners have a yellow/orange flame on them. We sometimes used to get this when the LP tank was about to "switch over", but now we are getting it almost all the time and on all the burners. Is there an adjustment somewhere to regulate the air/gas mix? Could this be a result of something in the regulator?, not enough or too much pressure? Our BH is a 2010 with a Magic chef stove.
thanks
al
 

jerryjay11

Well-known member
First thing to do is clean the burners. That can be done by placing them in a pot of boiling water. Or try brushing them off. Be sure they are completely dry before using them. Next I would check the regulator and I don't believe you'll find an adjustment.
 

rxbristol

Well-known member
Pop the top of the stove up and make sure the burner tube is properly connected to the incoming manifold. If the plastic seal is melted that is between the burner tube and manifold then you have a gas leak and flame at the manifold.
 
Top