Results 1 to 4 of 4

Thread: Party deck question.

  1. Print this Post   #1
    Junior Member
    Join Date
    Jun 2013
    Location
    USA - VA
    Posts
    9

    Party deck question.

    We just purchased an Edge 351 that has the rear party deck with the slide door and rear steps. My question is in regards to the rear steps and back rail, the rear steps have to be in place for the back gate/rail section to be sturdy. Is there a bracket/kit that allows the rear section of the party deck to be better secured without installing the rear steps? We may not always want the steps or may end up on an un-level site where the steps can't be installed, then we would have a flimsy rear rail. Just wondering if anyone has thought about or fixed this issue. Thanks in advance.

  2. Print this Post   #2
    Junior Member
    Join Date
    Jun 2013
    Location
    USA - VA
    Posts
    9

    Re: Party deck question.

    After talking with a manufacturer's rep I learned that the two sliding bars on top of the gate area are the only 'securing' points when the steps are not utilized. The railing is a little flimsy for my liking but it would take alot to get it to slide/push off of the ramp door. Is what it is I guess.

  3. Print this Post   #3
    Utah Chapter Leaders
    Join Date
    Jan 2017
    Location
    USA - UT
    Posts
    133

    Re: Party deck question.

    We never use our steps on the party deck. The railing is just fine. It is actually quite sturdy. It rests against the brackets where the steps mount so you could not push it off without lifting it over the bracket. It would be intentional not an accident.
    "May you live as long as you want, and never want as long as you live"

    Jeff, Kim & Jameson

    2018 Cyclone 4250
    2017 F-350 Superduty SRW
    2016 Polaris RZR-4
    Air-Lift XL7500 Air Springs
    Anderson Ultimate Hitch




  4. Print this Post   #4
    Junior Member
    Join Date
    Jun 2013
    Location
    USA - VA
    Posts
    9

    Re: Party deck question.

    There are no brackets on the top side of our door, we must have different models of the patio railings. The only brackets for our steps are on the bottom side of the door. Our patio setup is manufactured by MorRyde.

Similar Threads

  1. Screen room for party deck
    By jmarnell in forum Cyclone - Modifications
    Replies: 3
    Last Post: 05-21-2018, 03:43 PM
  2. Where to store party deck stairs
    By Edsbow in forum EDGE - General Discussions
    Replies: 2
    Last Post: 09-04-2016, 10:11 PM
  3. Party Booth Photos
    By SparkyD in forum Oakmont - Prospective Owners
    Replies: 1
    Last Post: 06-30-2016, 11:26 AM
  4. Igloo Party Bar
    By HornedToad in forum Camping Products
    Replies: 5
    Last Post: 05-10-2015, 05:31 PM
  5. Party deck for the 321?
    By TravisJen in forum Torque - Ask the Factory
    Replies: 11
    Last Post: 03-05-2013, 10:45 PM

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •