Cyclone Awning

jgreenedr

Member
Hello:

I have a 2012 Cyclone 3950 with one large awning. The awning has stopped working and is in the retracted position. The fuse panel is fine. Where do I start looking so I can fix the awning?

Thanks, Jerome
 
Last edited by a moderator:

boatto5er

Founding VA Chap Ldr (Ret)
First stop would be the switch. Use a voltmeter to see if you have 12v DC at the switch (on the side leading to the awning. Next stop for me would be the motor on the slide.


Sent from my iPhone using Tapatalk
 

david-steph2018

Well-known member
Like said check your switch. But also keep in mind just looking at the fuse may not show it bad. Use a meter and read the fuse to make sure the fuse is good.
 

jgreenedr

Member
Like said check your switch. But also keep in mind just looking at the fuse may not show it bad. Use a meter and read the fuse to make sure the fuse is good.

Thanks!

- - - Updated - - -

First stop would be the switch. Use a voltmeter to see if you have 12v DC at the switch (on the side leading to the awning. Next stop for me would be the motor on the slide.


Sent from my iPhone using Tapatalk

Thanks!
 
Top