Auto Level System

i4110peter · Aug 30, 2019

I have looked through the forum and manual locations, but don't see the Auto Level System that I have. It is Lippert, but I don't see any model numbers. Seem the level calibration went south on this last trip. Here are pictures of my unit. Please let me know if anyone has the same. I'm looking for instructions on re-calibration. Thanks in advance.

danemayer · Aug 30, 2019

That looks like the Lippert One Control leveling system. Take a look at the docs in this folder. Calibration is done from the panel inside the coach.

i4110peter · Aug 30, 2019

danemayer said:
That looks like the Lippert One Control leveling system. Take a look at the docs in this folder. Calibration is done from the panel inside the coach.

Thank you very much! Just got back from a short trip and the auto level would not work. When leveled manually, the system said front to back was-9.9. After several hours, it seem to reduce the amount until down to -1.3, and I was able to auto level. The road home was quite twisty and I don't know if this cause the issue. First time for everything. Thanks again.

mlpeloquin · Aug 30, 2019

One of the sensors may have come loose. It has happened on the other LPI system leveler reported here on the forum. On that one, which is what I have, it has been the rear sensor.

i4110peter · Aug 30, 2019

mlpeloquin said:
One of the sensors may have come loose. It has happened on the other LPI system leveler reported here on the forum. On that one, which is what I have, it has been the rear sensor.

And where would these sensors be located? Thank you.

Kathi-27 · Aug 30, 2019

rear sensor should be on cross member behind fresh water tank in the middle.

Auto Level System

i4110peter

Active Member

Attachments

danemayer

Well-known member

i4110peter

Active Member

mlpeloquin

Well-known member

i4110peter

Active Member

Kathi-27

Well-known member

Similar threads