Repairs

carl.swoyer

Well-known member
Walked into the Landmark to remove the toilet for a rebuild and the Norcold refrigerator was beeping with a L1 op. Grabbed the magnet and performed the reset. Apparently my lawn irrigation got water in the back of the fridge.

Then the toilet repair.
A thetford style ii model number 42054
Installed the new ball and seal. We were getting a very small leak around the pedal so a new water valve was also put in.
Now when I was looking at the backside of the pedal I noticed that there was a small area that was much dirtier than the rest. It happens to be right next to ball control arm.
I removed the original and found that the seal was damaged. Hopefully after a static leak test I have successfully rebuilt the toilet
Picture 1 static leak test.
Pic 2 leak source .
Pic 3 crushed and failed seal.
Pic 4 New Ball and seal.
Pic 5. I'm going to snip the tip on the vacuum valve ( on right) and install a spray hose.

Pic 6. My new steps and boy oh boy are they nice. If you're looking to replace your old ones these are the best
7c7f98b1830c0d7a68b138b8eccf01bd.jpg
dd06748f3bdda183804546d79c964f72.jpg
90b4202e3a0b0399f2d7468471954fea.jpg
323e2673a4ffbe1bdc7d2d5e217cc16c.jpg
9f4f2c8792d88c492a948dd3ab690d78.jpg
635cf1e2dcd8ddf463a907762da6b92b.jpg
 
Last edited:

carl.swoyer

Well-known member
Don
It sure is! So far my repair list is as follows.
Rebuilt my Onan 5500 lp, stator rotor assembly $650
Repairs to my Norcold 200bucks ( dealership said I needed a new one) 36° on setting 3
New breaks 900.$
Hydraulic pump new brushes installed 170.$ (a new one cost 1200)
And I'm sure there's more.

Sent from my moto z3 using Tapatalk
 
Top