front

Looking for replacement panel front "MALLARD" sign name plastic front panel, flip open plastic cover for 1987 model year, 29 FK, floor plan, thanks...

I bought a 2013 29bdss last week and going over the unit I noticed the front and rear walls are not solid like the side walls. I was just wondering if the front and rear walls are not supposed to be laminated. This is not a used unit. The dealer says he thinks it's not supposed to be. He went...

Please confirm the title/subject. I'd be happy to hear a confirmation by Heartland RV, Sundance division. I did not find ans. @heartlandrv.com. I ordered the SD3300QS w/ Chateau Decor and was told production would start end of August. I was also told by my salesman that I would get the new...

I will be installing a stronger rod on my BC tomorrow. I was at Home Depot, and found an 8 foot long strong rod and strong steel ends, and will be installing it tomorrow. The rod and shelve is bending with all the load and I am sure a stronger rod will prevent all this bending and assure the...

2010 3300RLB. how are the front steps that go up to the bedroom attached/secured? i need access under the steps for a project i am doing.

no longer a heartland owner

I have a broken leveling jack (on the off door side of my 2009 2900MK) and need to jack it up to get the weight off that leveling jack in order to replace a part in it. Where is the best place to use a bottle jack to raise that side of the trailer high enough to get my truck hooked up? Should I...

I've only hooked and unhooked 3 times since buying my Cyclone. I noticed on the non motor side of the landing gear I can not get the pull pin that drops the leg to seat 100%. In other words, on the other side, I can see the tip of the pin in the hole on the inside of the leg extension. I tried...

We just bought our 2009 BC 3500 home yesterday. Storms in CA might have caused rain to come in the front door. The rain was coming down sideways at times. We had a small square piece of carpet that was left by the front door by the dealership. After the storm passed we decided to open the door...

I know this is the place to post this problem. We just spent the weekend with some friends. They own a 08 Montana 5th wheel. I was trying to beat him to the dump station the last morning. As I pulled past him laughing I could see he was having problems with the Montana's front legs. I pulled...

We had our new Cyclone out several times this season, and every time we try to extend the landing gear more than 12", the in-line fuse blows on the landing gear motor. 12" is usually not enough to level front-to-back. Also, the motor seems to run very slowly. I have searched the forum, and this...

So the tech comes out and replaces the gear box and gets ready to leave and I start the switch and the motor runs but the legs don't move. Darn he says I should have checked the motor too. Said it would take another week for the part. Took a ride around Pahrump and no one had the part and...

I know this had been posted before but I can't seem to find an answer. We were camping and when I tried to raise the front landing gear it clicked and then stopped going up, so I hooked up by using the hand crank, which was really tough by the way, and got hitched. Today I looked for the nut...

I heard a clicking noise:confused: when raising my landing gear a few minutes ago. Took a look and the nut had come off the screw that holds the shaft that turns the gears that raise the front jacks (whew, thats a mouthfull:rolleyes:). The screw had backed out about half way and was hitting...

Gentlemen, I got a little shy about extending and retracting the front supports after reading about blowing fuses after retract bottoming out. I marked a safe retract line on my Sundance Ultralight front support. In order to get the front down low enough to achieve an acceptable degree of...

While cleaning up trailer I have located some damage to my nose cap. There is a gouge in the fiberglass and the door side front wrap around decal is torn. It is located on the leading edge of the nose cone in a black area of the decal, and my eyesight could not see it from any distance. I did...

I own a 2009 Sundance 2998rb. I always block my front legs at least with 2 or 3 pieces of 1 foot 2x12's. I have a mark on my front legs because I was blowing fusses. Lesson learned. Know I bring it home and only one leg wants to drive down with the motor. I pulled the pin on the long bar...

We left the campground today, but while raising the front jacks I noticed that as they were just about all the way up they stopped. They would not work any more. The rig is loaded on the truck so we got home o.k., but I can't get the rig off the truck. I am calling the dealer tomorrow so...

My sundance 3300 rlb shoreline inlet plug is in rear of 5th wheel , as I suppose all sundance are . Has anyone installed a 50 amp shorline inlet plug near front of 5th wheel to keep from using an extension power cord ? If so how would be a safe way to do this ?

I'm sitting in the middle of the Grand Tetons with my relativley new Sundance 5th wheel and for some reason my front landing gear is not working. It has been working all week on my way here. Is there an inline fuse somewhere; a fuse; anything I can look at? I was able to lower them manually...

We are new owners of a 3914, which we LOVE! This is our first fifth wheel, and front-to-back leveling seems to be a bit different from our previous 30ft travel trailer-type toy hauler. Side-to-side is the same, but we run out of landing leg length when we level front-to-back. Our first time, the...

Here in Texas my dealer recommended adding an additional AC for the bedroom, so we did and it worked fine. It is a Carrier Air V Standard Unit. However, since you need a 50 amp hookup to use both AC's it hasn't had much use. Now that we have the rig on the road and are able to plug into 50...

We have a 2010 Landmark Augusta. We were releveling it this evening & the front jacks stopped working. They are fully extended. There is no motor noise at all now. Is there a fuse somewhere, or something else we can check? Thank you for any & all help.

Just back from first trip 2800rls got to yellowstone park and wanted to remove trailer from truck and the jacks failed. the motor runs the cross shaft turns both shafts on the jacks the jacks are not loose. we dropped the jacks and they supported the trailer so we could spend 2 days in the park...

OK Guys - any quick ideas? I'm sitting here at American Heritage Campground in VA with the left front electric jack working and the right front jack not working. Left one goes up and down normally, right one won't move. Possible quick fixes? I made an appointment with my dealer for Monday...

I put Pro Comp ES9000 shocks on the front of my 05 2500 diesel 4x4 and I now have a rattle in the front. Sounds like no shocks at all. Upper rubbers or secure and bottom is secure. Anyone used these shocks before?

I was able to remove the cover to the doorside front jack and lube it but I can not figure out how to get to the streetside jack to do it. Has somebody figured this out and lube it?

Hi, I don't even have our trailer yet as we pick it up Saturday.But I already have plans to put in a power vent in the front vent of our 22fds.What I am wondering since it is just a standard vent is power there under the frame or will I have to get it from the light next to it. Thanks: Bob

What are the new blue LED light for on the front of the 2010 Cyclones? On the web site they call them running lights. I thought having blue lights on your vehicle was Illegal? These lights are very bright. Just not sure what purpose they service? besides just being kewl.

Well I finally got fed up with having to be a contortionist to turn on the light in the front storage compartment. While I was at the local Lowes store I picked up a grey plastic switch box, black light switch and black coverplate. I already had a short piece of 1/2" conduit at the house so no...

I have a Classic Landmark Mt. Rushmore and all the electrical outlets on the front wall of the coach are dead, this includes the one in the front side of the bedroom slide, the one in the closet, one above the dresser on front wall and the one in the bedroom cubby hole where the tv plugs in. I...

Has anyone had the front jacks motor go bad? Mine lets out a little groan and quits when trying to raise. I did see sparks fly out of the front of the motor. It will lower tho. Cranking it up by hand really sucks. Is it easily replaced?

I was just cleaning off the black streaks from the gutter on my 3210 and noticed that one side of my front cap seal has opened up just about 1/4". The gap is between the wall and the cover for the seam at the very bottom just before the cover turns under the front. I cannot find any easy...

I use the tripod and landing gear to stabilrize the front of my "ultralite" trailer when parked. However there are 7 Heartland units nearby that do not use the tripod BUT some use jack stands, concrete blocks, blocks of wood and bottle jacks. Do I need something in addition to the landing...

Hi everyone. I just ordered a 2010 Sundance 3300RLB last weekend after enjoying a Wildcat 28BH for 7 years. Great trailer with an unbelievable amount of storage, just not all that well constructed overall. But the best thing was that the kids bunk room at the back was raised up so that I had...

JT Strongarm stabilizers on sale locally and will buy a set however the model I purchase depends on the distance apart of the front landing gear. I think the legs are on the outside of the frame however I think I need confirmation of the distance between the two legs. Can anyone supply that...

Hi Everyone, Just a heads up to check your 5th wheel landing leg "snaps", the spring loaded pins you pull to release the legs. They are nowhere near what the original snaps are. My door side one came apart at the welds, I fail to see these how they call these welds. Looking at the other side, it...

Has anyone put a television in the front bedroom? If so, where and how?

:confused:We have a 2009 Bighorn 3055. When the front landing jacks are down, the front end looks fine but when the trailer is loaded and sitting on the pickup the underside of the front end and the front sidewalls have a gap of 1/2 to 3/4 inch. The caulk seal in this area is broken. The trailer...

Hello, I hooked and unhooked my rig today and noticed that the off door side seemed lower that the door side. I finished unhooking and ran the front jacks up and down to see if they were working properly. The off side door jack is not going up or down, only the door side moves. looked at several...