Routemaster
Well-known member
Was there a owner here on this forum that had a Bighorn and installed a all in one. Our Splendid washer is playing up again those boards are spendy.
All in one washer dryer
- Thread starter Routemaster
- Start date
Routemaster
Well-known member
My wife liked the idea of the top loader just like the old days but now after doing the research they say the new ones are not as good the old ones.
The pocket where we would place it has enough room with a little work with moving the drain pipe snug against the wall and a gas line installed.
Apart from that after taking the Splendide out for the third time in as many years. Checking measurements as one would do in the pocket see what I found not happy at all It is looking like the out side wall runs at a taper further out as the wall goes up and this with my tool makers 1"gauge block this is only over 72" surely this was not past by QC. Why the washer closet door would not close without slamming no wonder why. This coach is a total nightmare from start to finish. ASP build.
The pocket where we would place it has enough room with a little work with moving the drain pipe snug against the wall and a gas line installed.
Apart from that after taking the Splendide out for the third time in as many years. Checking measurements as one would do in the pocket see what I found not happy at all It is looking like the out side wall runs at a taper further out as the wall goes up and this with my tool makers 1"gauge block this is only over 72" surely this was not past by QC. Why the washer closet door would not close without slamming no wonder why. This coach is a total nightmare from start to finish. ASP build.
Attachments
Last edited:
Routemaster
Well-known member
As a toolmaker we all ways had a QC department which is "quality control" when in England and worked on parts they were checked and recorded.
