ATF: Cyclone - Noise in 6 point leveling system

[Riski]

I have a 12014 Cyclone 4100-King and it's been awesome. I put it in inside storage for three months and when I went to raise the rear jacks a clicking noise occurred without the jacks moving. I extended them and it worked as expected then retracted them, working as expected without the clicking. Then, once hooked up, I tried to raise the front jacks with the same clicking. I attempted to extend them and the clicking continued. Then, I raised them and the worked as expected. i am concerned that this could be the beginning of a bigger issue and would hate to get back out on the road again with the 6 point leveling system not working. The clicking noise is coming from the front regardless of the jacks being raised. Any advice?

 

[Jesstruckn/Jesstalkn]

So over that 3 month were you plugged in to shore power or was it just sitting there on battery power ?
Kinda sounds like low battery voltage from sitting. you can check your Voltage on the Level-up control panel, just scroll down until you see the voltage reading.