How to remove front cover of WFCO Distribution Center

[Dr.Lightning]

I have a 2018 Heartland Pioneer PI RK 280 travel trailer with a WF-8900 series WFCO Power Center (breaker/fuse box). I need to inspect/change DC branch circuits reaching this box. The front cover removal isn't visually obvious. I'd rather not assume something snaps, but then break it. Any advice on how to remove the front cover? Not the whole box, just the front cover. The Wiring Diagram suggests there are screw terminals accessible from the front. I can't easily see those but I understand where they must be.

No, the "Installation Instructions" don't mention how to add or remove the front cover.

Thanks in advance!

 

[Dr.Lightning]

OK, I was too impatient and I have the answer already.

It was indeed the most obvious two screws at the top, plus two tabs at the bottom. The screws are behind the flip-down door, and near the left and right upper corners. Just remove those, then the cover tilts down and you can lift out from the tab engagement.

Reverse to re-install.