Infinity Mirrors.

Rjslcuts

Member
We have a RW 413 and our infinity mirrors have slipped and fell down. Has anyone else had this problem and if so what did you do to fix them?:(
 

Dave_Jari

Member
Rj,
Ours are doing the same thing. Currently have slid down approximately 2 inches. Have you dug into it and find a solution. I never use them, and could have lived without them. By the way, our rig is an '18 427.
 

Rjslcuts

Member
Rj,
Ours are doing the same thing. Currently have slid down approximately 2 inches. Have you dug into it and find a solution. I never use them, and could have lived without them. By the way, our rig is an '18 427.
We redone ours. Took side boxes down unhooked wires. Ordered poly carbon sheets to size, ordered mirror and 2 way mirror film for panels. Replaced and silicones panels and lights in. Turned out decent but if they fall again definitely will do something different. Redone them for about 250.00. Reasonable instead of $450 from Heartland per panel and did not have but 2 because special made from outside manufacturer.
Hope this helps.
 

Attachments

  • D2806529-6BC1-42B4-B3E3-097EA1E79CD8.jpg
    D2806529-6BC1-42B4-B3E3-097EA1E79CD8.jpg
    181.5 KB · Views: 21
  • 34F10C25-A542-4EA3-A9AE-EBBAF61A6A4B.jpg
    34F10C25-A542-4EA3-A9AE-EBBAF61A6A4B.jpg
    124.9 KB · Views: 21
  • 4CFC6D23-704D-47AD-8FDA-3D086428DCF9.jpg
    4CFC6D23-704D-47AD-8FDA-3D086428DCF9.jpg
    99.1 KB · Views: 18

Dave_Jari

Member
We redone ours. Took side boxes down unhooked wires. Ordered poly carbon sheets to size, ordered mirror and 2 way mirror film for panels. Replaced and silicones panels and lights in. Turned out decent but if they fall again definitely will do something different. Redone them for about 250.00. Reasonable instead of $450 from Heartland per panel and did not have but 2 because special made from outside manufacturer.
Hope this helps.

Rj,
Thank you for your reply! One question, were the original panels unusable when you opened them up? Two questions I guess, can you put a small wooden block on the bottom edge to keep them from migrating downward again?

Thanks,
Dave D
 

Rjslcuts

Member
Rj,
Thank you for your reply! One question, were the original panels unusable when you opened them up? Two questions I guess, can you put a small wooden block on the bottom edge to keep them from migrating downward again?

Thanks,
Dave D[/yes you can take them apart and place a piece of wood to hold them in place. Ours was really stuck and when we tried to get glue off they detoriated and scratch. Ours had slid way down.
 
Top